Abstract:A new hybrid method based on the combination of the sol–gel process and the hydrothermal route was successfully used to prepare Pb 1 − x Mg x TiO 3 (PM x T) powders with x = 0.0, 0.05, 0.1, 0.2 and 0.3 at low temperature below 200 °C. By modifying the value of x, the impact of the Pb/Mg ratio on the structural, morphological and dielectric characteristics was examined. Analysis of the compounds obtained using X-ray diffraction (XRD) and Rietveld refinement method shows that all the compounds crystallize in a pure perovskite-type phase, demonstrating that magnesium doping within the quadratic structure of PbTiO 3 (P4mm) reduces the tetragonality (c/a) of the crystal lattice, and the proportion of the pseudo-cubic structure (Pm3m) increases progressively, reaching a maximum of 92.38% at a magnesium concentration of x = 0.3. Examination using a scanning electron microscope (SEM) shows that the average grain size decreases as a function of the Mg content, ranging from 4.371 μm for pure PbTiO 3 to 0.412 μm for PT-Mg with x = 0.3. The frequency-dependent dielectric properties were studied by complex impedance spectroscopy in the temperature range from RT to 550 °C where a structural phase transition and two anomalies A and B were observed as a function of temperature at different measurement frequencies for all ceramics, showing a decrease in maximum permittivity (ε rmax ) with magnesium content down to a low value around 30% magnesium (ε = 1248.86), with no significant influence on the ferroelectric-paraelectric transition temperature. The nature of the transition was studied using the Curie-Weiss law, which showed that diffusivity increased with Mg 2+ ion concentration. This may be explained by compositional fluctuations and structural disorder in the cation arrangement at crystallographic sites.

The Effect of Ti Doping on the Growth of Mg Nanostructures by Oblique Angle Codeposition

Effect of Fe-doping on bending elastic properties of single-crystalline rutile TiO<sub>2</sub> nanowires

Doping Effects of Ta on Conductivity and Microwave Dielectric Loss of MgTiO<sub>3</sub> Ceramics

Microstructures and Properties of N-Doped TiO_2 Films Grown by Dielectric Barrier Discharge Chemical Vapor Deposition

Effect of Ti Addition on the Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn Alloys

Effect of Mg and Cu co-doping on nanostructured TiO2 photocatalytic activity

Effects of Ti Doping on the Structures and Magnetic Properties of Films

Effects of Mg2+ doped TiO2 defect structures on TiO2 anatase-to-rutile phase transition

The Effect of Zn2+ Ion Doping on the Surface Morphology and UV Photoelectric Properties of Nanocristalline TiO2 Film Electrode

The Critical Effect of Niobium Doping on the Formation of Mesostructured TiO2 : Single-Crystalline Ordered Mesoporous Nb-TiO2 and Plate-like Nb-TiO2 with Ordered Mesoscale Dimples

Atomic Insights into Ti Doping on the Stability Enhancement of Truncated Octahedron LiMn2O4 Nanoparticles

Effects of Nb and Sr Doping on Crystal Structure of Epitaxial BaTiO3 Thin Films on MgO Substrates

Effects Of Nb Doping On Microstructure And Photocatalytic Properties Of Tio2 Thin Film

Effect of Magnesium Doping on the Growth and Dielectric Properties of (pb,sr)tio3 Thin Films Deposited by Rf Magnetron Sputtering

Tailoring Band Structure of Tio2 to Enhance Photoelectrochemical Activity by Codoping S and Mg

Effect of Magnesium Content on Precipitation Behavior of TiN-Containing Inclusions in High-Titanium High-Strength Steel

Fabrication and Optical-Electrical Properties of P-Type Manganese-Doped Titanium Dioxide Nano-Films

d0 Ferromagnetism in Mg-doped Rutile TiO2 Nanoparticles

Effect of addition of nanoparticle TiO2/SiO2 on the superconducting properties of MgB2

Preparation and Protein Adsorption Property of Mg-Incorporated TiO2 Nanodot Film

Impact of Mg doping on the structural, morphological and dielectric properties of PbTiO3 ceramics synthesized by consecutive combination of sol–gel and hydrothermal methods at low temperature