Abstract:P-doped TiO2 nanoparticles were synthesized by the sol-gel method with various H3PO4 amounts. The samples were calcinated at different temperature and charactered by XPS, ICP, XRD, SEM, Raman, FTIR, and UV-vis methods, so that the formation process of phosphate species could be inspected. The XRD results show that P species hinder the particle growth of anatase and increase the anatase-to-rutile phase transformation temperature to more than 900 degrees C, and a new titanyl phosphate, Ti5O4(PO4)(4), was observed in P-doped TiO2 when calcined at 1000 degrees C. The UV-vis results indicate that the P species is likely to have two different states, leading to the variety of visible-light photocatalytic activity and band gap energy of P-doped TiO2. One state is the "separated phase". In this state, the P/Ti ratio is very low so that the P species is surrounded by TiO2. The "separated phase" of P species introduces oxygen into TiO2 lattice and hence causes a red-shift of the adsorption band edge of anatase, leading to the increased visible-light photocatalytic activity of P-doped TiO2. The other state is the "congregated phase". It appears at the micro region where the ratio of P/Ti is high enough to make the TiO2 clusters isolated by P species. The "congregated phase" of P species acts as the interface phase between TiO2 clusters and strongly retards the crystal growth of anatase, resulting in the widened band gap of P-doped TiO2. Furthermore, a possible mechanism was also proposed to explain the formation of the two phases during the sol-gel process. The results indicate that in order to improve the visible-light photocatalytic activity of P-doped TiO2 the percentage of "separated phase" in P species needs to be enhanced.

Tailoring Band Structure of Tio2 to Enhance Photoelectrochemical Activity by Codoping S and Mg

Optimizing Photoelectrochemical Properties Oftio2by Chemical Codoping

Anatase TiO2 Codoping with Sulfur and Acceptor IIB Metals for Water Splitting

Improved Performance of Dye Sensitized Solar Cells Using Cu-doped TiO2 As Photoanode Materials: Band Edge Movement Study by Spectroelectrochemistry

Band Structure Tuning of TiO 2 for Enhanced Photoelectrochemical Water Splitting

Tailoring Structural, Electronic, Optical, and Photocatalytic Properties of Y 2 Ti 2 O 7 through a Passivated Codoping Approach

Synergistic Effect of V/N Codoping by Ion Implantation on the Electronic and Optical Properties of Tio2

Photonic, and Photocatalytic Behavior of Tio2 Mediated by Fe, Co, Ni, N Doping and Co-Doping

First-Principles Investigation of the Band Structure of S-Doped TiO2

Effect of Compensated Codoping on the Photoelectrochemical Properties of Anatase TiO2 Photocatalyst

Ti, Zn Co-Doped Hematite Photoanode for Solar Driven Photoelectrochemical Water Oxidation

Band Structure Engineering of Anatase TiO2 by Metal-Assisted P-O Coupling

Tailoring the electronic structure of anatase TiO2(001) surface through W and N codoping: a DFT calculation

Codoping synergistic effects in N-doped SrTiO3 for higher energy conversion efficiency

Enhanced Optical Absorption and Photocatalytic Activity of Cu/N-Codoped Tio2 Nanocrystals

(Mo+n) Codoped TiO2 for Enhanced Visible-Light Photoactivity

The Electronic Structure and Optical Properties of Donor-Acceptor Codoped TiO2 Nanosheets from Hybrid Functional Calculations

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

TiO2 Band Restructuring by B and P Dopants

Oxygen Vacancy Mediated Band-Gap Engineering via B-Doping for Enhancing Z-Scheme A-TiO2/R-TiO2 Heterojunction Photocatalytic Performance

Synergistic effect of V/N-codoped anatase TiO2 photocatalysts