Abstract:P-doped TiO2 nanoparticles were synthesized by the sol-gel method with various H3PO4 amounts. The samples were calcinated at different temperature and charactered by XPS, ICP, XRD, SEM, Raman, FTIR, and UV-vis methods, so that the formation process of phosphate species could be inspected. The XRD results show that P species hinder the particle growth of anatase and increase the anatase-to-rutile phase transformation temperature to more than 900 degrees C, and a new titanyl phosphate, Ti5O4(PO4)(4), was observed in P-doped TiO2 when calcined at 1000 degrees C. The UV-vis results indicate that the P species is likely to have two different states, leading to the variety of visible-light photocatalytic activity and band gap energy of P-doped TiO2. One state is the "separated phase". In this state, the P/Ti ratio is very low so that the P species is surrounded by TiO2. The "separated phase" of P species introduces oxygen into TiO2 lattice and hence causes a red-shift of the adsorption band edge of anatase, leading to the increased visible-light photocatalytic activity of P-doped TiO2. The other state is the "congregated phase". It appears at the micro region where the ratio of P/Ti is high enough to make the TiO2 clusters isolated by P species. The "congregated phase" of P species acts as the interface phase between TiO2 clusters and strongly retards the crystal growth of anatase, resulting in the widened band gap of P-doped TiO2. Furthermore, a possible mechanism was also proposed to explain the formation of the two phases during the sol-gel process. The results indicate that in order to improve the visible-light photocatalytic activity of P-doped TiO2 the percentage of "separated phase" in P species needs to be enhanced.

Band Structure Engineering of Anatase TiO2 by Metal-Assisted P-O Coupling

Optimizing Photoelectrochemical Properties Oftio2by Chemical Codoping

Anatase TiO2 Codoping with Sulfur and Acceptor IIB Metals for Water Splitting

Band Structure Tuning of TiO 2 for Enhanced Photoelectrochemical Water Splitting

TiO2 Band Restructuring by B and P Dopants

First Principles Calculations of the Electronic Structure and Optical Properties of Pure and (nb, N) Co-Doped Anatase

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

Effect of Compensated Codoping on the Photoelectrochemical Properties of Anatase TiO2 Photocatalyst

Synergistic effect of V/N-codoped anatase TiO2 photocatalysts

Tailoring Band Structure of Tio2 to Enhance Photoelectrochemical Activity by Codoping S and Mg

First-principles Study on Transition Metal-Doped Anatase TiO2.

Impact of Oxygen Vacancy on Band Structure Engineering of N-P Codoped Anatase Tio2

Univariate Lattice Parameter Modulation of Single-Crystal-like Anatase TiO2 Hierarchical Nanowire Arrays to Improve Photoactivity

Facile Construction TiO2/ZnIn2S4/Zn0.4Ca0.6In2S4 Ternary Hetero-Structure Photo-Anode with Enhanced Photo-Electrochemical Water-Splitting Performance

Dual active sites over TiO 2 homojunction through tungsten doping and oxygen vacancies for enhanced photoelectrochemical properties

Oxygen Vacancy Mediated Band-Gap Engineering via B-Doping for Enhancing Z-Scheme A-TiO2/R-TiO2 Heterojunction Photocatalytic Performance

Surface Energy-Driven Solution Epitaxial Growth of Anatase TiO2 Homostructures for Overall Water Splitting

Double-Hole-Mediated Coupling Of Anionic Dopants In Perovskite Nanbo3 For Efficient Solar Water Splitting

Manipulating the electronic and photocatalytic properties of anatase TiO2 by metalloid doping

Enhancement of Titania Photoanode Performance by Sandwiching Copper between Two Titania Layers

Role of Titanium replacement with Pd atom on band gap reduction in the anatase Titanium Dioxide: First-Principles calculation approach