Abstract:High pressure can significantly increase the densification. Further, during the high pressure assisted sintering, the nucleation rate is increased due to reduced energy barrier and the growth rate is suppressed due to the decreased diffusivity. Thus high pressure enables the specimen to be fabricated with relatively lower temperature and shorter sintering period that assures to obtain dense nanocrystalline ceramics. Dense nanocrystalline BaTiO3 ceramics with uniform grain sizes of 60 and 30 nm, respectively, were obtained by pressure assisted sintering. The crystal structure and phase transitions were investigated by Raman scattering at temperatures ranging from -190 to 200 degrees C. The Raman results indicated that the evolution of Raman spectrum with grain size is characterized by an intensity decrease, a broadening of the line width, a frequency shift, and the disappearance of the Raman mode. With increasing temperature, similar to 3 mm BaTiO3 normal ceramics, the successive phase transitions from rhombohedral to orthorhombic, orthorhombic to tetragonal, and tetragonal to cubic were also observed in nanocrystalline BaTiO3 ceramics. In addition, when particle size is reduced to the nanoscale, one will find some unusual physical proper-ties in nanocrystalline ceramics, compared with those of coarse-grained BaTiO3 ceramics. The different coexistences of multiphase were found at different temperature. Especially, the ferroelectric tetragonal and orthorhombic phase can coexist at room temperature in nanocrystalline BaTiO3 ceramics. The phenomenon can be explained by the internal stress. The coexistences of different ferroelectric phases at room temperature indicate that the critical grain size for the disappearance of ferroelectricity in nanocrystalline BaTiO3 ceramics fabricated by pressure assisted sintering is below 30 nm

Significant Increase Of Curie Temperature In Nano-Scale Batio3

Phase Transition In Batio3 Nanotube Arrays

In-situ thermal phase transition and structural investigation of ferroelectric tetragonal barium titanate nanopowders with pseudo-cubic phase

Observation Of Ferroelectric Domain Patterns In Nanocrystalline Batio3 Ceramics

Phase Coexistence Evolution of Nano BaTiO3 As Function of Particle Sizes and Temperatures

Temperature and Applied Field Effect on Ferroelectric Properties of Nanocrystalline BaTiO_3 Ceramics

Temperature-Dependent Electrical Properties of 0.94Bi<sub>0.5</sub>Na<sub>0.5</sub>TiO<sub>3</sub>-0.06BaTiO<sub>3</sub>Ceramics

CO Catalytic Oxidation of Pt-Loaded Perovskite BaTiO3 Near Ferroelectric-Phase Transition Temperature

Temperature-Dependent Electrical Properties Of 0.94bi(0.5)Na(0.5)Tio(3)-0.06batio(3) Ceramics

The Phase Transitions and Ferroelectric Behavior of Dense Nanocrystalline BaTiO 3 Ceramics Fabricated by Pressure Assisted Sintering

Low-temperature Synthesis of TiB2 Nanocrystals Using TiO2 ,LiBH4 and Mg

Thermal Stability of the Nanostructured Batio3 Determined by Long and Short Range Interactions: A Dual-Shell Model

Size Effect Investigation on Nano-Scale Ferroelectric Ceramic Materials

Abnormal Cubic-Tetragonal Phase Transition of Barium Strontium Titanate Nanoparticles Studied by in Situ Raman Spectroscopy and Transmission Electron Microscopy Heating Experiments

Study on Positive Temperature Coefficient of Resistivity of Co-Doped BaTiO3 with Curie Temperature in Room Temperature Region

The Study on High Temperature Conductivity of Nanocrystalline BaTiO3 Ceramics

Temperature Dependence on the Dielectric and Ferroelectric Properties of Nanocrystalline BaTiO_3 Ceramics

Study On Thermal Control Behavior By Using Batio3-Based Ptc Materials With Room Temperature Curie Point

Raman Studies of Nanocrystalline Batio3 Ceramics

Ferroelectric BaTiO3 Nanoceramics Prepared by a Three‐step High‐pressure Sintering Method

Study on microstructure and properties of nanograin ferroelectric ceramics