Abstract:Compared with simply supported beams, continuous steel-concrete composite beams have many advantages such as higher span/depth ratio, less deflection, and higher fundamental frequency of vibration due to its higher stiffness. However, in negative bending regions near interior supports, tension in concrete is unfavorable and a complicated issue, which deserves a special study. In this paper, a mechanics model based on elastic theory was established to investigate the stiffness of composite beams in negative bending regions by considering slips at the steel beam-concrete slab interface and concrete-reinforcement interface. In order to validate this approach, a test of three composite beams with profiled sheeting under negative bending was conducted. Meanwhile, a three-dimensional nonlinear finite element (FE) analysis was conducted to investigate the general behavior of the tested specimens. In addition, a comparative analysis between results derived from the analytical model, laboratory test, and FE analysis was performed. The results show that slip always exists for composite beams under negative bending even with complete shear connection (full composite action) between the steel and concrete components. The slip effect results in an additional curvature of beam bending and reduces the section stiffness by 10-20% compared with that of a beam without any slip in serviceability condition. This reduction should be considered in designing process especially for cantilever beams. Formulae under other loading cases and boundary conditions were also proposed. The results can serve as a basis for further study on stiffness of continuous steel-concrete composite beams and can directly be used for the deflection calculation of cantilever beams.

Lateral Buckling Analysis of the Steel-Concrete Composite Beams in Negative Moment Region

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

A Ductility-Centred Analytical Model for Axially Restrained Double-Span Steel Beam Systems Subjected to Sudden Columns Loss

A unified analysis for distortional and lateral buckling of C-purlins in flexure

A UNIFIED ANALYSIS METHOD FOR DISTORTIONAL AND GLOBAL BUCKLING OF Z-PURLINS IN FLEXURE

Reduced Stiffness of Composite Beams Considering Slip and Shear Deformation of Steel

Distortional and Lateral Buckling of Z-Purlins with Sloping Lips in Flexure

Lateral Buckling of Web-Tapered I-beams: A New Theory

Analytical Theory of Composite Beams with CSWs Using the State Space Method

A Controversy and Its Settlement in the Calculation of Buckling Moments of Thin-walled Beams with Monosymmetrical I-sections under Distributed Loads

Elastic flexural-torsional buckling of thin-walled cantilevers

Structural behavior of steel-concrete composite slim beam in the negative moment region

Stiffness Calculation for Negative Moment Region of Steel-Concrete Composite Beams considering the Influence of Cracking and Interface Slip

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Mechanical Behavior of Elastic Buckling of Composite Steel Concrete Beams

Experimental and analytical research on the flexural behaviour of steel–ECC composite beams under negative bending moments

Stiffness and Deflection of Steel–Concrete Composite Beams under Negative Bending

Analysis of Equivalent Flexural Stiffness of Steel–Concrete Composite Beams in Frame Structures

Experimental research on negative bending behavior of steel-ECC composite beams

ANALYSIS OF COMPOSITE BEAM STIFFNESS UNDER NEGATIVE BENDING

Bearing Capacity Calculation of Steel-Concrete Composite Beam under the Action of Negative Moment