Abstract:Compared with simply supported beams, continuous steel-concrete composite beams have many advantages such as higher span/depth ratio, less deflection, and higher fundamental frequency of vibration due to its higher stiffness. However, in negative bending regions near interior supports, tension in concrete is unfavorable and a complicated issue, which deserves a special study. In this paper, a mechanics model based on elastic theory was established to investigate the stiffness of composite beams in negative bending regions by considering slips at the steel beam-concrete slab interface and concrete-reinforcement interface. In order to validate this approach, a test of three composite beams with profiled sheeting under negative bending was conducted. Meanwhile, a three-dimensional nonlinear finite element (FE) analysis was conducted to investigate the general behavior of the tested specimens. In addition, a comparative analysis between results derived from the analytical model, laboratory test, and FE analysis was performed. The results show that slip always exists for composite beams under negative bending even with complete shear connection (full composite action) between the steel and concrete components. The slip effect results in an additional curvature of beam bending and reduces the section stiffness by 10-20% compared with that of a beam without any slip in serviceability condition. This reduction should be considered in designing process especially for cantilever beams. Formulae under other loading cases and boundary conditions were also proposed. The results can serve as a basis for further study on stiffness of continuous steel-concrete composite beams and can directly be used for the deflection calculation of cantilever beams.

Mechanical Behavior of Elastic Buckling of Composite Steel Concrete Beams

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

PLASTIC ANALYSIS OF SHEAR BEHAVIOR OF COMPOSITE STEEL-CONCRETE BEAMS

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

Elastic Flexural-Torsional Buckling of Doubly Symmetric Web-Tapered I-Beams

Composite Shear Behavior of Steel-Concrete Composite Beams under Sagging Moment

Bending Stiffness of Steel-Concrete Composite Beams Considering Effect of Slip

Reduced Stiffness of Composite Beams Considering Slip and Shear Deformation of Steel

Mechanical Behavior of Box Girder Bridge with Partial Corrugated Steel Webs

Experimental Studies on Shear Strength of Steel–Concrete Composite Beams

OUT-OF-PLANE STABILITY OF MONOSYMMETRIC WEB-TAPERED I-BEAMS

STUDY ON LOCAL BUCKLING OF WEBS OF COMPOSITE BEAMS SUBJECTED TO POSITIVE BENDING MOMENT

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Comparative study of the negative bending behaviour of corrugated web steel–concrete composite beams using NC, ECC and UHPC

Experimental research on negative bending behavior of steel-ECC composite beams

Buckling of Piecewise Member Composed of Steel and High-Strength Materials in Axial Compression

Experimental Study on Composite Steel- HSC Beams

Stiffness and Deflection of Steel–Concrete Composite Beams under Negative Bending

Experimental and Theoretical Research on Mechanical Behavior of Innovative Composite Beams

Elastic Web Buckling Stress and Ultimate Strength of H-Section Beams Dominated by Web Buckling

ANALYSIS OF COMPOSITE BEAM STIFFNESS UNDER NEGATIVE BENDING