Abstract:Bamboo-concrete composite (BCC) beams are newly-innovated products used for floor system which synergistically utilizes bamboo and concrete components. These composite beams at cur-rent technology belong to the beam characterized with partial composite action due to the ex-istence of relative slip between bamboo segment and concrete slab. Existing investigations have demonstrated that the load bearing capacity of BCC beams depends on their bending stiffness; however, very limited prediction models are available to accurately estimate the bending stiffness of BCC beams. At present, the bending stiffness of BCC beams is predicted with the help of gamma-method in Eurocode 5-Part 1-1, and available studies have demonstrated that this method overestimates the bending stiffness of BCC beams. To this end, this paper presents a novel explicit model characterized with mechanism and data mining to predict the bending stiffness of BCC beams under short-term loads. Three steps were performed to achieve the aforementioned research objective. The first step was to introduce the axial force transfer coefficient into the equilibrium equations of internal force for bamboo segment and concrete slab. Secondly, the bending stiffness of BCC beams was established by taking into account the effect of relative slip with the help of existing experimental results from the interfacial shear test and flexural test. Finally, the proposed model was validated by comparing with flexural performance results of BCC beams collected from available literature as well as those obtained from gamma-method. The comparative results show that: i) the predicted bending stiffness of BCC beams is much closer to tested ones compared with gamma-method; ii) the errors of proposed model predicting the bending stiffness for most BCC beams are within 10% of test results; however, nearly half of the predicted ones using gamma-method have errors exceeding 10% of test results, both of which verify that the mechanism and data mining-dual driven model receives a better prediction for short-term bending stiffness of BCC beams.

Stiffness Calculation for Negative Moment Region of Steel-Concrete Composite Beams considering the Influence of Cracking and Interface Slip

Bending Stiffness of Steel-Concrete Composite Beams Considering Effect of Slip

Reduced Stiffness of Composite Beams Considering Slip and Shear Deformation of Steel

Analysis of Composite Beams with Interlayer Slip

Bending Stiffness of Bamboo-Concrete Composite (BCC) Beams under Short-Term Loads

Stiffness and Deflection of Steel–Concrete Composite Beams under Negative Bending

Stiffness Calculation Method for Steel-Concretecontinuous Composite Beams

ANALYSIS OF COMPOSITE BEAM STIFFNESS UNDER NEGATIVE BENDING

Calculation of Long-Term Slippage for Externally Prestressing Steel-Concrete Composite Beam

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Experimental and analytical research on the flexural behaviour of steel–ECC composite beams under negative bending moments

Structural behavior of steel-concrete composite slim beam in the negative moment region

Experiment Analysis on Crack Resistance in Negative Moment Zone of Steel-Concrete Composite Continuous Girder Improved by Interfacial Slip

Static and Fatigue Behavior of Steel-Concrete Composite Beams with Corroded Studs

Experimental research on negative bending behavior of steel-ECC composite beams

Fatigue Performance of Prefabricated Composite T‐beams under Cyclic Overloading: an Experimental Study

Deflection and Crack Calculation of Corroded Reinforced Concrete Beams

STIFFNESS OF STEEL-CONCRETE COMPOSITE FRAME BEAM WITH SLIP EFFECT

Analysis of Equivalent Flexural Stiffness of Steel–Concrete Composite Beams in Frame Structures

EFFECTS OF SLIPS ON LOAD-CARRYING CAPACITY OF COMPOSITE BEAMS UNDER NEGATIVE BENDING

Stiffness and Cracking Behavior of New U-Shaped Steel and Concrete Composite Beam under Negative Bending