Abstract:A novel Ti2AlC particle and in-situ TiAl3 reinforced pure Al composites with different preparation temperature were fabricated by pressure-infiltration technique. The microstructure, phases and compressive strength of 45% Ti2AlC-Al system composites were studied. Compress test and XRD results reveal that the composite consisting 50% TiAl3 exhibits the best properties when the fabrication temperature was 1023 K. SEM results reveal that the presence of in-situ TiAl3 phase can great influence the interface bonding status. After carefully controlling the interface structure, the composite showed excellent compressive strength (1250 MPa) and specific strength (385 MPa.cm(3)/g) properties compared with other MAX-type or TiAl3 reinforced Al composites. High temperature test demonstrated that great strength and good ductility properties were maintained after heating above 773 K. Three strengthening mechanisms were discussed to characterize the mix-phase (Ti2AlC + TiAl3)/Al composites. The results indicate that high strength of in-situ TiAl3 phase and good deformation ability of Ti2AlC phase contribute to the improvement in compression behavior. This simple and efficient preparation method of MAX phase reinforced Al-based composite provides a new sight for high-performance metal matrix composites.

Fabrication of in Situ Ti 2 AlN/TiAl Composites by Reaction Hot Pressing and Their Properties

In Situ TiBw/Ti–6Al–4V Composites with Novel Reinforcement Architecture Fabricated by Reaction Hot Pressing

Microstructural Characteristics and Evolution of Ti2AlN/TiAl Composites with a Network Reinforcement Architecture During Reaction Hot Pressing Process

Synthesis and Mechanical Properties of TiB2/Ti2AlN Composites Fabricated by Hot Pressing Sintering

Processing, Microstructural Characterization and Mechanical Properties of in Situ Ti3AlC2/TiAl3 Composite by Hot Pressing

Microstructure and Mechanical Properties of Ti2AlC-reinforced TiAl Composites

Design and Strengthening Behaviour of Ti2alc/Tial Composite by Low-Temperature Hot-Pressing Process

Microstructural characterization and mechanical properties of TiAl–Al2Ti4C2–Al2O3–TiC in situ composites by hot-press-aided reaction synthesis

Fabrication and mechanical properties of Ti2AlN/TiAl composite with continuous network structure

Reaction synthesis, microstructure, and mechanical properties of in-situ TiAl-based multiphase composites

Microstructure Formation Mechanism of (al2o3+tib2+al3ti)/al Composites Fabricated by Reactive Hot Pressing

Microstructure and Mechanical Properties of Ti2AlC Particle and In-Situ TiAl3 Reinforced Pure Al Composites

In-situ TiC/Ti composites based on Ti 2 AlC–Ti system: Reaction process, microstructure, and mechanical properties

Tailoring Ultrafine Grained and Dispersion-Strengthened Ti2AlC/TiAl Composite Via a New Fabrication Route

Microstructure and mechanical properties of Ti3(Al,Ga)C2/Al2O3 composites prepared by in situ reactive hot pressing

The Fabrication and Properties of the Squeeze-Cast TiN/Al Composites

Preparation and characteristics of Ti3AlC2 -Al3Ti/Al composite materials synthesized from pure Al and Ti3AlC2 powders

Manufacture and Properties of AlON-TiN Particulate Composites

Preparation and Mechanical Properties of TiN-Al<sub>2</sub>O<sub>3</sub> Refractory Composites

Mechanical Properties and Electrical Conductivity of Tin-Al2o3 Nanocomposites

The microstructure and tensile properties of the Ti 2 AlC reinforced TiAl composites fabricated by powder metallurgy