Abstract:A numerical modeling study, based on 3D finite element method (FEM) simulation and 1D analytical solutions, has been carried out to evaluate the capabilities of two ac methods for measuring in-plane thermal conductivity of thin film deposited on the back of a suspended SiNx membrane setup. Two parallel metal strips are present on the top of the dielectric membrane. One strip (S1) serves as both heater and thermometer, while another one (S2) acts as thermometer only. For a modified phase shift (MPS) method, it is crucial to extract the in-plane thermal diffusivity from the phase shift of the temperature oscillation on S2. It was found that the frequency window for carrying out the data fitting became narrower as the in-plane thermal diffusivity of the composite membrane (<math>α∥,C</math>) increased, primarily due to the failure of the semi-infinite width assumption in the low frequency region. To ensure the validity of the method, the upper limit of <math>α∥,C</math> should not exceed ~1.8 × 10−5 m2 s−1 for the specific membrane dimension under consideration (1 × 1 mm2). On the other hand, inspired by a modified Ångström method proposed by Zhu recently, we suggest a new data reduction methodology which takes advantage of the phase shift on both S1 and S2 as well as the amplitude on S1. Based on the simulation results, it is expected that the non-ideality associated with the three "observables" may be at least partially canceled out. Therefore, the frequency window selection for carrying out the data fitting is not sensitive to the magnitude of <math>α∥,C</math> and the upper limit of measurable <math>αC,∥</math> can be further increased with respect to the MPS method. For typical specimen films whose in-plane thermal conductivity ranges from 0.84 W m−1 K−1 to 50 W m−1 K−1, the method proposed here yields a theoretical measurement uncertainty of less than 5%.

Calculations of the Microwave Conductivity of High-Tc Superconducting Thin-Films from Power Transmission Measurements

A Simplified Power Transmission Method Used for Measuring the Complex Conductivity of Superconducting Thin Films

Research on Effective Area of Surface Resistance Measurement of Superconducting Thin Film at Microwave Frequencies

THE MEASURING PRECISION ANALYSIS OF SURFACE RESISTANCE IN MICROWAVE BAND BASED ON IEC/TC90

Nonlinear Surface Resistance of YBa2Cu3O7-x Superconducting Thin Films on MgO Substrates in Dielectric Resonator at Ultra High Frequencies

The Approximate Analytic Expressions For Field Dependence Of Surface Impedance Of High-T-C Superconducting Thin Film In Low- And Intermediate-Field Region

Universal scaling of the critical temperature for thin films near the superconducting-to-insulating transition

ERROR ANALYSIS FOR MEASUREMENTS OF MICROWAVE SURFACE RESISTANCE OF HIGH-TEMPERATURE SUPERCONDUCTORS BY DIELECTRIC RESONATOR METHOD

RESEARCH ON MICROWAVE PROPERTY OF HIGH-TC SUPERCONDUCTOR

Surface resistance of superconducting microwave passive devices

Measurement of the Thermal Transport Properties of Dielectric Thin Films Using the Micro-Raman Method

Simple test for high Jc and low Rs superconducting thin films

MEASUREMENT OF THE SURFACE RESISTANCE OF HTS FILMS BY TWO DIELECTRIC RESONATORS METHOD

How the Surface Resistance R s of Patterned High- T c Superconducting Thin Film Is Affected by the Film's Edge

Current distribution of high-Tc superconducting microstrip lines

Transient Determination on the Bulk Thermal Conductivity of Sub-Millimeter Thin Films of Composite Phase Change Thermal Interfacial Materials

RF field-attenuation formulae for the multilayer coating model

Numerical modeling of in-plane thermal conductivity measurement methods based on a suspended membrane setup

Discussion of the Superconducting Critical-Temperature in an N-S Multifilm Structure

Thermal Conductivity Measurements of Ultra-Thin Single Crystal Silicon Films Using Improved Structure

The Critical Current Density Distribution in a TlBaCaCuO Thin Film Ring Resonator