Abstract:Plastic deformation of polyethylene in uniaxial and biaxial loading conditions is studied using molecular dynamics simulation. Effects of tensile strain rates from 1 × 10 5 to 1 × 10 9 s −1 , and mass density in the range of 0.923–0.926 g/cm 3 on mechanical behaviour and microstructure evolution are examined. Two biaxial tensile deformation modes are considered. One is through simultaneous stretching in both the x and y directions and the other sequential stretching, firstly in the x-direction and then in the y-direction while strain in the x-direction remains constant. Tangent modulus and yield stress that are determined using the stress–strain curves from the molecular dynamics simulation show a strong dependence on the deformation mode, strain rate and mass density, and all are in good agreement with results from the experimental testing, including fracture behaviour which is ductile at a low strain rate but brittle at a high strain rate. Furthermore, the study suggests that the stress–strain curves under uniaxial tension and simultaneous biaxial tension at a relatively low strain rate contain four distinguishable regions, for elastic, yield, strain softening and strain hardening, respectively, whereas under sequential biaxial tension, stress increases monotonically with the increase of strain, without noticeable yielding, strain softening or strain hardening behaviour. The molecular dynamics simulation also suggests that an increase in the strain rate enhances the possibility of cavitation. Under simultaneous biaxial tension, with the strain rate increasing from 1 × 10 6 to 1 × 10 9 s −1 , the molecular dynamics simulation shows that polyethylene failure changes from a local to a global phenomenon, accompanied by a decrease of the void size and increase of uniformity in the void distribution. Under sequential biaxial tension, on the other hand, the density of the cavities is clearly reduced.

Structural and Rheological Property Relationship of Bimodal Polyethylene with Improved Environment Stress Cracking Resistance

The Microstructure-Tensile Property Relationship of Polyethylene Resin for Biaxially Stretched Film

Molecular Mobility in the Amorphous Phase Determines the Critical Strain of Fibrillation in the Tensile Stretching of Polyethylene

The Chain Microstructure And Condensed Structure Of Polyethylene Resin Used For Biaxially Stretched Film

Investigations of Environmental Stress Cracking Resistance of HDPE/UHMWPE and LDPE/UHMWPE Blends

Investigations of Environmental Stress Cracking Resistance of HDPE/EVA and LDPE/EVA Blends

Coupling effects of spinodal decomposition and crystallization on mechanical properties of polyolefin blends

Deformation and Molecular Orientation in Films of Metallocene Polypropylene, Ethylene-Butylene Rubber, and Their 80/20 (W/W) Blend Revealed by the Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism, Macroscopic Stress, and Mesoscale Strain

The Effect of Branched Structure on the Lamellae Evolution under Uniaxial Extension and SCG Resistance of Polyolefins

Influences of Molecular Weight and Crystalline Structure on Fracture Behavior of Controlled-Rheology-Polypropylene Prepared by Reactive Extrusion

Effect of Temperature on Environmental Stress Cracking Resistance and Crystal Structure of Polyethylene

Dynamic Rheology Behavior of Bimodal Polyethylene

Structure Evolution of Polyethylene in Sequential Biaxial Stretching along the First Tensile Direction

Understanding structure-mechanics relationship of high density polyethylene based on stress induced lattice distortion

Crystallization and Fracture Behaviors of High‐density Polyethylene/linear Low‐density Polyethylene Blends: the Influence of Short‐chain Branching

Relationship between Microstructure and Mechanical Properties of Ethylene-Octene Copolymer Reinforced and Toughened PP

Static and Dynamic Properties of Semi-Crystalline Polyethylene

Structure-rheology properties of polyethylenes with varying macromolecular architectures

Molecular dynamics simulation of plastic deformation in polyethylene under uniaxial and biaxial tension

Branches, Tie Chains and Entanglements in Bimodal Polyethylene Single Crystals under Uniaxial Tensile Strain

Structure/property relationship of semi-crystalline polymer during tensile deformation: A molecular dynamics approach