Abstract:Three-dimensional (3D) micro -nano fabrication through two -photon polymerization (TPP) is a prominent approach for fabricating complex 3D structures. However, the existing techniques face limitations, such as small fabrication area, dependence on high numerical aperture (e.g., oil immersion) objective lenses, which are more expensive. We developed a 780 nm fs laser system integrated with a 2D galvanometer system and Z axis to create a 3D micro -nano printing system. A method to print arbitrarily complex 3D structures while maintaining an extremely high lateral spatial resolution of sub-100nm is proposed by using a cheap low numerical aperture objective lens with the laser power and exposure time precisely controlled. The impact of the laser power and exposure time on the resolution of 3D micro -nano processing is investigated, and we identify the optimal processing environment for achieving the best resolution. The printed linewidth of 62 nm was achieved without the use of an oil immersed objective lens, and only one laser beam was used instead of stimulated emission depletion. Microneedle arrays for animal injection were fabricated using this strategy, which can improve the performance of animal organoid repair. Our results suggest that TPP micro -nano fabrication is an effective method for processing microneedle arrays for biomedical engineering, with the ability to improve the processing resolution with a cheap low numerical aperture objectives lens (e.g., NA = 0.4) through meticulous control of laser power and exposure time. This approach opens up possibilities for affordable and scalable fabrication in sub-100nm structures.

Fabrication of SU-8 Microneedle Based on Backside Exposure Technology

A New Low-Cost Fabrication Method for Micro Electro Mechanical System Microneedles

A novel technology for fabricating microneedle of SU-8

Design and Fabrication of Micro Needles Array Based on UV-LIGA Technology

A new low-cost fabrication method of SU-8 micro–nano channels and needle tip in electro-hydrodynamic jet chips

Hollow metallic microneedles fabricated by combining bulk silicon micromachining and UV–LIGA technology

Fabricating SU-8 Photoresist Microstructures with Controlled Convexity–Concavity and Curvature through Thermally Manipulating Capillary Action in Poly(dimethylsiloxane) Microholes

A New Diamond Machining Approach for Extendable Fabrication of Micro-Freeform Lens Array

An Improved Manufacturing Approach for Discrete Silicon Microneedle Arrays with Tunable Height-Pitch Ratio.

Application of Inclined and Rotating UV Lithography in Preparation of Micro-needles

Out-of-Plane Hollow Microneedles Fabricated by Combining Silicon and Non-Silicon Method

Microneedle fabrication using the plane pattern to cross-section transfer method

Fabrication of Microneedles Using Two Photon-Polymerization with Low Numerical Aperture

Design and Fabrication of Drug-Loaded Metal Microneedle

Study on Novel MEMS Hollow Microneedle Array

Fabrication of a polymer micro needle array by mask-dragging X-ray lithography and alignment X-ray lithography

Fabrication of a Three-Layer SU-8 Mould with Inverted T-shaped Cavities Based on a Sacrificial Photoresist Layer Technique

Fabrication and characterization of a tungsten microneedle array based on deep reactive ion etching technology

Fabricating High-Resolution and High-Dimensional Microneedle Mold through the Resolution Improvement of Stereolithography 3D Printing

Fabrication of bulk titanium out-of-plane microneedles

Research of Fabricating Transdermal Drug Delivery Solid Silicon Microneedles Based on Dicing and Wet Etch