Abstract:Adv. Mater. 2011, 23, 5440–5444 electromechanical properties of the strain sensor measured by monitoring the current at different strain state at a fixed voltage of+ 10 V. We checked the current flow through the device by stretching the device step by step under 0%, 1.5%, 3%, 4%, and 8% strain (each step was held for 15 s) and then released gradually from 8% to 4%, 3%, 1.5%, and 0%, as illustrated in Figure 2 c. It can be seen that the current switched rapidly at every turning point, the current remained identical under the same strain, and no remarkable current change was observed at a certain strain state. The device preserved the superb response and recovery properties even under an ultrahigh strain of≈ 30%(Figure 2 d), which indicates attractive perspective in applications such as precision measurements. It is now widely accepted that environentally benign devices will be very important for future applications in daily life for health monitoring and entertainment purposes.[30, 31] We tested the electromechanical sensing of the fabricated sensor on the human body to demonstrate the potential uses in wearable electronics. An as-fabricated strain sensor was fixed onto an index finger. We checked the currents flow through the device (at a fixed voltage of+ 10 V) at four different bending and release motions of the finger, which are labeled as state I, II, III, and IV in the upper insets in Figure 3. In each bending–unbending motion, the finger bent to the same angle in every cycle, held for 10 s, and then released. It can be observed that the sensor responsed to the motion of the finger rapidly and the current recovered to the original value at every …

Fabrication of Ultra-High-sensitivity Flexible Strain Sensor Based on Single ZnO Nanowire

Novel ZnO Nanorod Flexible Strain Sensor and Strain Driving Transistor with an Ultrahigh 107 Scale “on”−“off” Ratio Fabricated by a Single-Step Hydrothermal Reaction

Active Flexible Strain Sensor Based on Single ZnO Micro/Nanowire

Automated Electrical Measurements of Single ZnO Nanowire with Cu and Au Electrodes Under Axial Strain

Highly sensitive and flexible strain sensors based on vertical zinc oxide nanowire arrays

Strain Sensing Mechanism of the Fabricated ZnO Nanowire-Polymer Composite Strain Sensors

High‐strain sensors based on ZnO nanowire/polystyrene hybridized flexible films

Strain Sensors Based on Single High-Quality Zno Microwires

Carbon Fiber-Zno Nanowire Hybrid Structures for Flexible and Adaptable Strain Sensors.

Highly Sensitive Wearable Strain Sensor Based on Silver Nanowires and Nanoparticles

Ultrahigh sensitive piezotronic strain sensors based on a ZnSnO 3 nanowire/microwire

Highly flexible strain sensor based on ZnO nanowires and P(VDF-TrFE) fibers for wearable electronic device

Improved Stretchable and Sensitive Fe Nanowire-Based Strain Sensor by Optimizing Areal Density of Nanowire Network

Flexible Microstrain Sensors Based on Piezoelectric ZnO Microwire Network Structure

FABRICATION AND PROPERTIES OF A MICROSTRAIN SENSOR BASED ON ZINC OXIDE NETWORK STRUCTURE

Piezotronic Strain Sensor Based on Single Bridged ZnO Wires

A High Sensitivity Single-Walled Carbon-Nanotube-array-based Strain Sensor for Weighing

A Flexible Multifunctional Sensor Based on an AgNW@ZnONR Composite Material

High Sensitivity, Wide Linear‐Range Strain Sensor Based on MXene/AgNW Composite Film with Hierarchical Microcrack

Silver Nanowire/Silver/Poly(dimethylsiloxane) as Strain Sensors for Motion Monitoring