Abstract:Adv. Mater. 2011, 23, 5440–5444 electromechanical properties of the strain sensor measured by monitoring the current at different strain state at a fixed voltage of+ 10 V. We checked the current flow through the device by stretching the device step by step under 0%, 1.5%, 3%, 4%, and 8% strain (each step was held for 15 s) and then released gradually from 8% to 4%, 3%, 1.5%, and 0%, as illustrated in Figure 2 c. It can be seen that the current switched rapidly at every turning point, the current remained identical under the same strain, and no remarkable current change was observed at a certain strain state. The device preserved the superb response and recovery properties even under an ultrahigh strain of≈ 30%(Figure 2 d), which indicates attractive perspective in applications such as precision measurements. It is now widely accepted that environentally benign devices will be very important for future applications in daily life for health monitoring and entertainment purposes.[30, 31] We tested the electromechanical sensing of the fabricated sensor on the human body to demonstrate the potential uses in wearable electronics. An as-fabricated strain sensor was fixed onto an index finger. We checked the currents flow through the device (at a fixed voltage of+ 10 V) at four different bending and release motions of the finger, which are labeled as state I, II, III, and IV in the upper insets in Figure 3. In each bending–unbending motion, the finger bent to the same angle in every cycle, held for 10 s, and then released. It can be observed that the sensor responsed to the motion of the finger rapidly and the current recovered to the original value at every …

Highly flexible strain sensor based on ZnO nanowires and P(VDF-TrFE) fibers for wearable electronic device

Highly Sensitive and Fast Response Strain Sensor Based on Evanescently Coupled Micro/nanofibers

Stretchable, Sensitive Strain Sensors with a Wide Workable Range and Low Detection Limit for Wearable Electronic Skins

Highly Stretchable Core-Sheath Fibers Via Wet-Spinning for Wearable Strain Sensors

Highly stretchable and durable fibrous strain sensor with growth ring-like spiral structure for wearable electronics

High‐strain sensors based on ZnO nanowire/polystyrene hybridized flexible films

A Highly Stretchable and Sensitive Strain Sensor Based on Dopamine Modified Electrospun SEBS Fibers and MWCNTs with Carboxylation

Design of Helically Double-Leveled Gaps for Stretchable Fiber Strain Sensor with Ultralow Detection Limit, Broad Sensing Range, and High Repeatability.

Highly Stretchable and Strain Sensitive Fibers Based on Braid-Like Structure and Sliver Nanowires

Flexible bifunctional sensor based on porous copper nanowires@IonGels composite films towards high-resolution stress/deformation detection

Highly Stretchable and Ultra-Sensitive Strain Sensing Fiber Based on a Porous Core-Network Sheath Configuration for Wearable Human Motion Detection

A Highly Stretchable and Ultra-Sensitive Strain Sensing Fiber Based on a Porous Core-Network Sheath Configuration for Wearable Human Motion Detection

Wearable Electronics: Polymer-Enhanced Highly Stretchable Conductive Fiber Strain Sensor Used for Electronic Data Gloves (Adv. Mater. Technol. 7/2016)

Highly Stretchable and Sensitive Strain Sensor with Porous Segregated Conductive Network.

In-situ Forming Ultra-Mechanically Sensitive Materials for High-Sensitivity Stretchable Fiber Strain Sensors.

Polymer‐Enhanced Highly Stretchable Conductive Fiber Strain Sensor Used for Electronic Data Gloves

A Fully-Stretchable And Highly-Sensitive Strain Sensor Based Liquid-State Conductive Composite

Highly Stretchable and Ultrasensitive Strain Sensor Based on Reduced Graphene Oxide Microtubes-Elastomer Composite.

Highly sensitive strain sensor based on ZnO nanofiber mat for medical applications

Highly Conductive PVA/Ag Coating by Aqueous in Situ Reduction and Its Stretchable Structure for Strain Sensor.

Tensible and Flexible High-Sensitive Spandex Fiber Strain Sensor Enhanced by Carbon Nanotubes/ag Nanoparticles