Abstract:Purpose - Conventional machining methods for fabricating piezoelectric components such as ultrasound transducer arrays are time-consuming and limited to relatively simple geometries. The purpose of this paper is to develop an additive manufacturing process based on the projection-based stereolithography process for the fabrication of functional piezoelectric devices including ultrasound transducers. Design/methodology/approach - To overcome the challenges in fabricating viscous and low-photosensitive piezocomposite slurry, the authors developed a projection-based stereolithography process by integrating slurry tape-casting and a sliding motion design. Both green-part fabrication and post-processing processes were studied. A prototype system based on the new manufacturing process was developed for the fabrication of green-parts with complex shapes and small features. The challenges in the sintering process to achieve desired functionality were also discussed. Findings - The presented additive manufacturing process can achieve relatively dense piezoelectric components (approximately 95 per cent). The related property testing results, including X-ray diffraction, scanning electron microscope, dielectric and ferroelectric properties as well as pulse-echo testing, show that the fabricated piezo-components have good potentials to be used in ultrasound transducers and other sensors/actuators. Originality/value - A novel bottom-up projection system integrated with tape casting is presented to address the challenges in the piezo-composite fabrication, including small curing depth and viscous ceramic slurry recoating. Compared with other additive manufacturing processes, this method can achieve a thin recoating layer (as small as 10 mu m) of piezo-composite slurry and can fabricate green parts using slurries with significantly higher solid loadings. After post processing, the fabricated piezoelectric components become dense and functional.

Ceramic fabrication using Mask-Image-Projection-based Stereolithography integrated with tape-casting

Fabrication of Three-Dimensional Inter-Connective Porous Ceramics Via Ceramic Green Machining and Bonding

Supportability of a High-Yield-Stress Slurry in a New Stereolithography-Based Ceramic Fabrication Process

Ceramics Fabrication Using Rapid Prototyping of Mask Projection Stereolithography

A Novel Aqueous Ceramic Suspension for Ceramic Stereolithography

Design of a Shaping System for Stereolithography with High Solid Loading Ceramic Suspensions

Direct Fabrication of an Integral Ceramic Mould by Stereolithography

Direct fabrication process of ceramics based on stereolithography

Oxygen-controlled Bottom-Up Mask-Projection Stereolithography for Ceramic 3D Printing

Development of a Novel Tape-Casting Multi-Slurry 3D Printing Technology to Fabricate the Ceramic/Metal Part

Preparation of silicon carbide ceramic slurry for stereolithography based additive manufacturing

High-resolution multiceramic additive manufacturing based on digital light processing

Preparation of photosensitive SiO2/SiC ceramic slurry with high solid content for stereolithography

Support-Free Ceramic Stereolithography of Complex Overhanging Structures Based on an Elasto-viscoplastic Suspension Feedstock.

A Novel Tape-Casting Multi-Slurry 3d Printing Technology to Fabricate a Ceramic/Metal Part

The Preparation of SiC Ceramic Photosensitive Slurry for Rapid Stereolithography

Piezoelectric component fabrication using projection-based stereolithography of barium titanate ceramic suspensions

Additive Manufacturing of Traditional Ceramic Powder Via Selective Laser Sintering with Cold Isostatic Pressing

Fabrication of ceramics using photosensitive slurries: A comparison between UV-casting replication and vat photopolymerization 3D printing

POLYMER-DERIVED SIC CERAMIC WITH TRIPLY PERIOD MINIMAL SURFACE STRUCTURE FABRICATION THROUGH DIGITAL LIGHT PROCESSING