Abstract:Achieving a viable process for three-dimensional (3D) printing of ceramics is a sought-after goal in a wide range of fields including electronics and sensors for harsh environments, microelectromechanical devices, energy storage materials, and structural materials, among others. Low laser absorption of ceramic powders renders available additive manufacturing (AM) technologies for metals not suitable for ceramics. Polymer solutions that can be converted to ceramics (preceramic polymers) offer a unique opportunity to 3D-print ceramics; however, due to the low viscosity of these polymers, so far, their 3D printing has only been possible by combining them with specialized light-sensitive agents and subsequently cross-linking them layer by layer by rastering an optical beam. The slow rate, lack of scalability to large specimens, and specialized chemistry requirements of this optical process are fundamental limitations. Here, we demonstrate 3D printing of ceramics enabled by dispensing the preceramic polymer at the tip of a moving nozzle into a gel that can reversibly switch between fluid and solid states, and subsequently thermally cross-linking the entire printed part "at-once" while still inside the same gel. The solid gel, which is composed of mineral oil and silica nanoparticles, converts to fluid at the tip of the moving nozzle, allows the polymer solution to be dispensed, and quickly returns to a solid state to maintain the geometry of the printed polymer both during printing and the subsequent high-temperature (160 °C) cross-linking. We retrieve the cross-linked part from the gel and convert it to ceramic by high-temperature pyrolysis. This scalable process opens up new opportunities for low-cost and high-speed production of complex three-dimensional ceramic parts and will be widely used for high temperature and corrosive environment applications, including electronics and sensors, microelectromechanical systems, energy and structural applications.

Fabrication of ceramics using photosensitive slurries: A comparison between UV-casting replication and vat photopolymerization 3D printing

Fabrication and characterisation of ceramics via low-cost DLP 3D printing

3Y-TZP DLP Additive Manufacturing: Solvent-free Slurry Development and Characterization

Preparation of high solid loading and low viscosity ceramic slurries for photopolymerization-based 3D printing

Photopolymerization of Ceramic Resins by Stereolithography Process: A Review

Development of ceramic-reinforced photopolymers for SLA 3D printing technology

Optimized Zirconia 3D Printing Using Digital Light Processing with Continuous Film Supply and a Recyclable Slurry System

Zirconia UV-curable colloids for additive manufacturing via hybrid inkjet printing-stereolithography

Photopolymerization-based additive manufacturing of ceramics: A systematic review

Embedded 3D Printing of Architected Ceramics via Microwave‐activated Polymerization

ScholarWorks@UTEP ScholarWorks@UTEP Material Synthesis and Additive Manufacturing of Ceramics Material Synthesis and Additive Manufacturing of Ceramics

Tomographic Volumetric Additive Manufacturing of Silicon Oxycarbide Ceramics

Vat photopolymerization 3D printing of ceramics: Effects of fine powder

On enhancing the manufacturability and conversion of additively manufactured polymer-derived ceramics

Three-Dimensional Printing of Ceramics through "Carving" a Gel and "Filling in" the Precursor Polymer

Additive manufacturing of flexible polymer-derived ceramic matrix composites

Development of a Novel Tape-Casting Multi-Slurry 3D Printing Technology to Fabricate the Ceramic/Metal Part

Preparation of silicon carbide ceramic slurry for stereolithography based additive manufacturing

Rheological behavior and curing deformation of paste containing 85 wt% Al2O3 ceramic during SLA-3D printing

Optimizing the properties of vat photopolymerization 3D-printed SiC ceramics by multi-infiltration