Abstract:Based on computational fluid dynamics, chemical reaction kinetics, principles of transfer in metallurgy, and other principles, a multi-fluid model for a traditional blast furnace was established. The furnace conditions were simulated with this multi-fluid mathematical model, and the model was verified with the comparison of calculation and measurement. Then a multi-fluid model for an oxygen blast furnace in the gasifier-full oxygen blast furnace process was established based on this traditional blast furnace model. With the established multi-fluid model for an oxygen blast furnace, the basic characteristics of iron ore reduction process in the oxygen blast furnace were summarized, including the changing process of the iron ore reduction degree and the compositions of the burden, etc. The study found that compared to the traditional blast furnace, the magnetite reserve zone in the furnace shaft under oxygen blast furnace condition was significantly reduced, which is conducive to the efficient operation of blast furnace. In order to optimize the oxygen blast furnace design and operating parameters, the iron ore reduction process in the oxygen blast furnace was researched under different shaft tuyere positions, different recycling gas temperatures, and different allocation ratios of recycling gas between the hearth tuyere and the shaft tuyere. The results indicate that these three factors all have a substantial impact on the ore reduction process in the oxygen blast furnace. Moderate shaft tuyere position, high recycling gas temperature, and high recycling gas allocation ratio between hearth and shaft could significantly promote the reduction of iron ore, reduce the scope of the magnetite reserve zone, and improve the performance of oxygen blast furnace. Based on the above findings, the recommendations for improvement of the oxygen blast furnace design and operation were proposed.

An Efficient Reactor for High-Lead Slag Reduction Process: Oxygen-Rich Side Blow Furnace

Study on oxygen side-blown reducing furnace and smelting reduction process of high-lead slag

Study on oxygen blowing optimisation of reducing (FeO) content in slag in EAF steelmaking process with high ratio of hot metal to scrap

Numerical Investigation of the Limit of Coke Rate Reduction in an Ironmaking Blast Furnace (BF)

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Preparation of High Performance Blended Cements and Reclamation of Iron Concentrate from Basic Oxygen Furnace Steel Slag

Synergetic modification of industrial basic oxygen furnace slag and copper slag for efficient iron recovery

Selective reduction of lead sulfate containing slag using the fluidized bed reactor

Clean recycling of Zn-bearing slags by a plasma fuming process

A Thermodynamic and Experimental Assessment of the Recovery of Copper, Iron, Zinc, and Lead from Copper Slag

Synergetic valorization of basic oxygen furnace slag and stone coal: Metal recovery and preparation of glass-ceramics

An efficient approach to utilize copper smelting slag: Separating nonferrous metals and reducing iron oxide at high temperature

Numerical Study of the Reduction Process in an Oxygen Blast Furnace

Iron Recovery and Active Residue Production from Basic Oxygen Furnace (BOF) Slag for Supplementary Cementitious Materials

Cleaning of high antimony smelting slag from an oxygen-enriched bottom-blown by direct reduction

Effect of Oily Sludge Treatment with Molten Blast Furnace Slag on the Mineral Phase Reconstruction of Water-Quenched Slag Properties

Optimization of manganese-rich slag extraction from low-manganese ore smelting by response surface methodology

A novel approach for the resource utilization of zinc-bearing dust and sludge via the blast furnace main trough

Kinetic and Thermodynamic Studies on Lead-Rich Slag Reduction at Various CaO/SiO2 Ratios

Enhanced recovery of zinc and lead by slag composition optimization in rotary kiln

Discussion on the LF Refining Slag Performance