Abstract:This work introduces the capacitively coupled contactless conductivity detection ( $\text{C}^{{4}}\text{D}$ ) technique into nondestructive testing (NDT) of carbon fiber-reinforced polymer (CFRP) and proposes a new resistance measurement method of CFRP tubes. The proposed method does not require direct contact between the electrodes and the carbon fiber. Therefore, the electrical resistance of CFRP can be measured without the treatments required by traditional electrical methods that may lead to surface or structural damage. The equivalent circuit model of the new method is established, and the challenges are analyzed. Simulation and experiment are conducted with woven fabric CFRP tubes to verify the feasibility of the proposed method, including the range of workable frequency, the effectiveness of the circuit model, and the capability of damage detection. Research results show that a relatively high working frequency is required to accurately measure the interested resistance and sense the resistance change. By selecting a workable frequency, the effectiveness of the circuit model is verified. Research results indicate that the stray capacitance between the electrodes has little effect on resistance measurement, and the capacitor–resistor–capacitor model is still applicable. Research results also verify the feasibility of the proposed method for damage detection. It is able to sense the resistance change resulted from the damage of CFRP, either the conductivity changes in simulation or actual cutting damage in experiment.

Monitoring the Damage Evolution of Flexural Fatigue in Unidirectional Carbon/carbon Composites by Electrical Resistance Change Method

Review of Self-Sensing of Damage and Interfacial Evaluation Using Electrical Resistance Measurements in Nano/micro Carbon Materials-Reinforced Composites

Tensile damage self-monitoring of carbon fiber/epoxy 3D braided composites with electrical resistance method

Study on Flexural Fatigue Life of Ultra-High Toughness Cementitious Composites under Constant Amplitude Cyclic Loading

A New Electrical Resistance Measurement Method of Carbon Fiber-Reinforced Polymer Tubes Based on C⁴D Technique

Self-Sensing Of Position-Related Loads In Continuous Carbon Fibers-Embedded 3d-Printed Polymer Structures Using Electrical Resistance Measurement

Non-destructive health monitoring of glass fibre epoxy composites under fatigue loading using electrical resistance change method

Mechanical-electrical coupling behaviors of 3-D carbon fiber angle-interlock woven composites under quasi-static and cyclic tension

Impact responses and residual flexural properties of narrow CFRP laminates

Delamination Analysis of Carbon Fiber/Epoxy Composite Laminates under Different Loading Rates Using Acoustic Emission

Structural health monitoring of carbon fiber reinforced matrix by the resistance variation method

Research on Piezoresistive Effect and Random Model of Carbon Fiber Bundle

Structural health monitoring of carbon nanotube-modified glass fiber-reinforced polymer composites by electrical resistance measurements and digital image correlation

Flexural progressive damage and failure behavior of carbon-aramid/epoxy hybrid woven composites

Stiffness Degradation for Fatigue of Reinforced Concrete Beams after Electrochemical Rehabilitation

Rate-dependent mechanical and self-monitoring behaviors of 3D printed continuous carbon fiber composites

Damage Monitoring of Regularly Arrayed Short-Fiber-Reinforced Composite Laminates under Tensile Load Based on Acoustic Emission Technology

Evaluation of Fatigue Damage Monitoring of Single-Lap Composite Adhesive Joint Using Conductivity

Damage Analysis of a SiCf/SiC Ceramic Matrix Composite under Stepwise Fatigue Loading with Acoustic Emission

Fatigue damage monitoring of composite laminates based on acoustic emission and digital image correlation techniques

Tensile strain and damage self-sensing of flax FRP laminates using carbon nanofiber conductive network coupled with acoustic emission