Abstract:For an accurate estimation of the fatigue performance of welded joints, not only the initial residual stress field but also its variation under load is decisive. The portion of residual stress which stays stable can shift the load stress range much the same way as the mean stresses do in fatigue loading. The relaxation of residual stresses during fatigue loading however reduces this hazard to the structural health. That is, before considering the influence of residual stresses in fatigue, the effect of fatigue on residual stresses should be understood. In this work, the influence of the quasi-static and cyclic loading on the relaxation of welding residual stresses in small specimens and large components out of different steels namely S235JRG2, S355J2G3, P460NL, S690QL, S960QL, and S1100QL has been investigated experimentally. X-ray diffraction analysis as a reliable method has been used for the determination of residual stress profiles in surface layers. For residual stress analysis in deeper layers, synchrotron and neutron diffraction techniques were applied as complementary methods. A clear recognition of the difference between initial welding residual stresses in small- and large-scale specimens was observed. Tensile residual stresses as high as the yield strength could appear in large-scale welded specimens. That was not the case for small-scale welds due to the low grade of restraint. Nevertheless, in both types of samples, the highest residual stresses were obtained in the weld centerline. At the weld toe which is critical regarding fatigue crack initiation, the magnitude of the residual stresses is lower. Beside of that, it was observed that in the case of relaxation, the first load cycles especially in components out of low-strength steels are decisive. The influence of loading conditions and local mechanical properties on the relaxation of welding residual stresses was investigated based on principles of solid mechanics. The von Mises failure criterion was able to describe the relaxation behavior.

Release and Redistribution of Residual Stress in the Welded Turbine Rotor under Service-Type Loadings

Estimation of Residual Stresses by Nanoindentation in an Experimental High Strength Microalloyed Steel Subjected to Rapid Thermal Cycles

Simulation of Residual Stress in Welded Steam Turbine Rotor and Its Effects on Fatigue Life

Stress relief investigation using creep model considering back stress in welded rotor

Effects of shrinkage fitting on the welding residual stresses of a large electromotor rotor

Research of Welding Residual Stress of Francis Turbine Runner

Numerical Investigation on Stress Distribution and Evolution in 9cr/2.25cr Dissimilar Welded Rotor Undergoing Welding and Heat Treatment

Welding residual stress behavior under mechanical loading

Virtual Optimization of Regulating and Controlling on Welding Residual Stress of Francis Turbine Runner

On the Mechanism of Residual Stresses Relaxation in Welded Joints under Cyclic Loading

Residual Stress Analysis in Linear Friction Welded Ti17

The Residual Stress Relaxation Behavior of Weldments During Cyclic Loading

Finite Element Analysis Model and Residual Stress Optimization in Rotor Welding Process

Residual Stress of Joints of Welded Turbine Rotors,Part 3: Residual Stress of 125 MW and 1 000 MW LP Turbine Rotors

A Model to Predict the Relaxation of Weld Residual Stress by Cyclic Load: Experimental and Finite Element Modeling

Analytical Model to Compare and Select Creep Constitutive Equation for Stress Relief Investigation during Heat Treatment in Ferritic Welded Structure

Analysis of Residual Stress Relief in Linear Friction Welded Ti17 During Post Weld Heat Treatment by Norton-Bailey Creep Model

Residual stresses evolution during strip clad welding, post welding heat treatment and repair welding for a large pressure vessel

Evolution of Residual Stresses in Dissimilar Steel Surfacing Layers During Process of Post-Weld Heat Treatment

Study of various parameters on residual stress relaxation for different welded components

Influence of Local Heating on Welding Residual Stress of Francis Turbine Runner