Abstract:Solar cavity receiver plays a dominant role in the light-heat conversion process of the solar power system. Its performance can directly affect the efficiency of the whole power generation system. The start-up thermal performance of a solar cavity receiver with boiling tubes and superheated tubes was experimentally studied. A six-side prism with inclined top and bottom was chosen as the solar cavity receiver. The inside wall heat flux of the receiver was evaluated and according to this condition the layout of boiling tubes and superheated tubes was considered. An experiment platform was designed for the thermal performance test of the receiver. The working substance is water and the electric heating was employed for simulating the solar heating. And the experiment platform can work a pressure range of 0 similar to 5.0MPa and a mass flow range of 0 similar to 100kg/h. During start-up the temperature rising rate is considered as a main control condition. A couple of reasonable rising curves of temperature were set according to different working pressures, and the mass flow was considered to rise linearly till to the target states. The start-up thermal efficiencies of the receiver under different working pressures were finally obtained with the result that the receiver performed relatively low thermal efficiencies of 55 similar to 70% in target states. A thermal loss evaluation was calculated. And the results show the thermal loss takes a large part of the total energy and the main reason of low thermal efficiencies is the low mass flow. The rising curves of superheated steam temperature, system pressure and heating power were also obtained. The temperature distribution and deformation of the tubes inside the receiver were measured as well. The results show the deformation of the tubes is linear with the temperature of the tubes.

Simulation and Experimental Study of an Air Tube-Cavity Solar Receiver

Experimental Study on Thermal Performance of a Water/steam Cavity Receiver with Solar Simulator

Numerical Simulation and Experimental Study of the Tube Receiver's Performance of Solar Thermal Power Tower

Experimental investigation on heat-transfer characteristics of a cylindrical cavity receiver with pressurized air in helical pipe

Simulation and Experimental Study on a Spiral Solid Particle Solar Receiver

Experimental studies on the flow and wall temperature distribution of solar cavity receiver under non-uniform heat flux

Numerical simulation of the heat flux distribution in a solar cavity receiver

Numerical Investigation on Uniformity of Heat Flux for Semi-Gray Surfaces Inside a Solar Cavity Receiver

Solar-thermal conversion investigation using surface partition method for a cavity receiver with helical pipe

An experimental investigation on thermal and optical analysis of cylindrical and conical cavity copper tube receivers design for solar dish concentrator

Experimental Study Of The Thermal Performance Of Solar Cavity Receiver During Start-Up Process

Experimental Study on a Coiled Tube Solar Receiver under Variable Solar Radiation Condition

An optimized model and test of the China’s first high temperature parabolic trough solar receiver

Thermal-Mechanical Coupling Analysis of Spiral Tube in Solar Cavity Receiver

Thermal performance simulation of a solar cavity receiver under windy conditions

PERFORMANCE SIMULATION OF SOLAR CAVITY RECEIVER

Design, Simulation and On-Sun Experiments of a Modified Sliding-Bed Particle Solar Receiver for Coupling with Tower Concentrating System

A STUDY ON BOILING HEAT TRANSFER OF SOLAR CAVITY RECEIVER

EXPERIMENTAL AND SIMULATION INVESTIGATION ON A PARABOLIC TROUGH SOLAR COLLECTOR

Inferences on the effects of geometries and heat transfer fluids in multi-cavity solar receivers by using CFD

Numerical and experimental study of a concentrated solar thermal receiver for a solar heating system with seasonal storage