Abstract:Circular accelerators used for positron emission tomography (PET, i.e. accelerator used for make radio isotopes) need several inA of CW H- ion beam for their routine operation. Other facilities, like Space Radio-Environment Simulate Assembly (SPRESA), require less than 10 mA pulsed mode it beam. Caesium free negative hydrogen ion source is a good choice for those facilities because of its compact structure, easy operation and low cost. Up to now, there is no it source able to produce very intense H- beams with important variation of the duty factor[1]. Recently, a new version of 2.45 OHz microwave it ion source was designed at PKU, based on lessons learnt from the previous one. This non cesiated source is very compact thanks to its permanent magnet configuration. Special attention was paid on the design of the discharge chamber structure, electron dumping and extraction system. Source test to produce Ef ion beams in pulsed and CW mode was carried out on PKU ion source test bench. In CW mode, a 10.8 mA/30keV H- beam with rms emittance about 0.16 minmnnrad has been obtained with only 500 W rf power. The power efficiency reaches 21 mA/kW. In pulsed mode with duty factor of 10% (100Hz/1ms), this compact source can easily deliver 20 mA H- ion beam at 35 keV with rms emittance about 0.2 pi.mm.mrad when RE power is set at 2.2 kW (peak power). Several hour successive running operation in both modes and totaling more than 200 hours proves its high quality. The outside dimension of this new H- source body is phi 116 mm x 124 mm, and the entire H- source infrastructure, including rf matching section, plasma chamber and extraction system, is phi 310 x180 nun The high voltage region is limited with in a phi 310 nun x 230 nun diagram. Details are given in this paper.

Improvements of PKU PMECRIS for Continuous Hundred Hours CW Proton Beam Operation.

New Progress on Beam Availability and Reliability of Pku High Intensity Cw Proton Ecr Ion Source

Continuous Operation of 2.45-Ghz Microwave Proton Source for 306 Hours with More Than 50 Ma DC Beam

Methods to obtain high intensity proton ion beams with low emittance from ECR ion source at Peking university

Intense Beams from Gases Generated by A Permanent Magnet Ecr Ion Source at Pku

Improvement of Miniaturized 2.45 GHz ECR Plasma Flood Gun at PKU

Upgrade of the Extraction System of Permanent Magnet Electron Cyclotron Resonance Ion Source

CW/Pulsed H− Ion Beam Generation with PKU Cs-free 2.45 GHz Microwave Driven Ion Source

A New Proton Injector Based on PKU-type 2.45ghz PMECR Ion Source for BNCT Facility

A Miniaturized 2.45 GHz ECR Ion Source at Peking University

Practical 2.45-Ghz Microwave-Driven Cs-free H − Ion Source Developed at Peking University

Possibility of Generating H+, or H2+, or H3+ Dominated Ion Beams with a 2.45 GHz Permanent Magnet ECR Ion Source

New Progress of a 2.45 GHz ECR Ion Source for Carbon Positive Ion Mass Spectrometry

Study on Proton Fraction of Beams Extracted from Electron Cyclotron Resonance Ion Source

The High-Brightness Ultra-Short Pulsed Electron Beam Source at Peking University

Four-Rod RFQ Beam Dynamics Design of PKUNIFTY Upgrade

STATUS OF THE HIGH CURRENT PERMANENT MAGNET 2.45GHZ ECR ION SOURCE AT PEKING UNIVERSITY

Further Improvement for 10be Measurement on an Upgraded Compact AMS Radiocarbon Facility

Beam Commissioning and Analysis of a Continuous-Wave Window-Type Deuteron Radio-Frequency Quadrupole

Stable Operation of the Dc-Srf Photoinjector

A 2.45 Ghz Electron Cyclotron Resonance Proton Ion Source and A Dual-Lens Low Energy Beam Transport