Abstract:The stability and reliability of an ion source and its beam availability are extremely significant for any accelerator,especially for those high current long term CW operation ones like ADS. Although the first high quality 306-hours continuous wave（CW） operating curve at 50 m A@35 ke V has been successfully obtained with a standard compact 2.45 GHz ECR ion source at Peking University（PKU）, but the uncertainties that caused beam trips before are unacceptable during an accelerator real operation and should be eliminated. Meanwhile, no permission will be given when the beam power is upgraded from 50 m A@35 ke V to 50 m A@50 ke V. To improve the PKU CW proton source quality, several upgrades were done recently. After those improvements, a new long term CW proton beam experiment at 50 m A@50 ke V was carried out in June 2016. The total running time is 300.5 hours, including near 6 hours ion source preparation and 294 hours non-disturb continuous operation. Within the continuous 13 days operation, no beam-off happened, no spark was observed,no beam drop appeared, no interrupting action was needed, and only a few beam fluctuations caused by the air conditional failure occurred. Beam availability and reliability within the 294 hours is 100%. The root-mean-square（RMS） emittance of this 50 m A@50 ke V CW proton beam is about 0.186 π.mm.mrad. A careful inspection of the ion source was done after this long term operation and no obvious damage was found. The restart experimental results obtained after the ion source inspection prove the high repeatability of PKU PMECRIS. In addition, a 130-m A H+beam was obtained at 50 k V with duty factor of 10%（100 Hz/1 ms） with this source. Details will be presented in this paper.

The High-Brightness Ultra-Short Pulsed Electron Beam Source at Peking University

High brightness CW electron beams from Superconducting RF photoemission gun

Design of A Source to Supply Ultra-Fast Electron and X-Ray Pulses

A Picosecond Pulsed Cold-Cathode Electron Gun for Ultrafast Electron Characterization and High-Frequency Radiation Source Applications

Design, Fabrication, and Beam Commissioning of a 216.667 MHz Continuous-Wave Photocathode Very-High-frequency Electron Gun

Generating Proton Beams Exceeding 10 MeV Using High Contrast 60TW Laser

Advanced drive laser system for a high-brightness continuous-wave photocathode electron gun

Researches of Thomson scattering ultra-short pulse X-ray source at Tsinghua University

Development of an L-band Photocathode RF Gun at Tsinghua University

RF design and high power tests of a new tsinghua photocathode RF GUN

First Beam Measurements of the S-Band Photocathode Radio-Frequency Gun at Tsinghua University

BEAM LOADING TESTS ON DC-SC PHOTOINJECTOR AT PEKING UNIVERSITY*

Generating 10~40MeV high quality monoenergetic electron beams using a 5TW 60fs laser at Tsinghua University

New Progress on Beam Availability and Reliability of Pku High Intensity Cw Proton Ecr Ion Source

Experimental Investigations of DC-SC Photoinjector at Peking University

Methods to obtain high intensity proton ion beams with low emittance from ECR ion source at Peking university

Primary Beam-Loading Tests on DC–SC Photoinjector at Peking University

Beam pulsing system for the 4.5MV electrostatic accelerator at Peking Univ

BEAM LOADING TESTS ON DC-SC PHOTOINJECTOR AT PEKING UNIVERSITY

Ultrafast Electron Beam Compression Using Chirped Pulse Beating Laser

BEAM PULSING SYSTEM FOR THE4.5 MV ELECTROSTATIC ACCELERATOR AT PEKING UNIVERSITY