Abstract:In the microelectronics industry the flip-chip (FC) technology is broadly used to enhance the packaging density. However, the small size and the unique geometry of the FC solder joints induce the electromigration (EM) reliability issue. In this study, a pair of lead-free solder joints (SAC1205) was EM tested by a current of 7.5 103 A/cm2. During the tests, X-ray laminography was applied to observe the microstructure evolution in-situ. Laminography enables the non-destructive observation of the bump microstructure and allows for a quantitative three-dimensional (3D) analysis. After EM testing for 650 h, a new EM failure mechanism was found, differing from the two well-known models, the pancake void propagation and the under-bump-metallization dissolution. Here, a few pre-existing small voids grew and simultaneously many new voids formed and grew over the entire EM testing period. Most of the nucleating voids were distributed in the current crowding region, a few also located in the low-currentdensity region. As the testing time increased, voids increasingly coalesced with each other, forming a porous network which occupied a large part of the interface area and caused the EM failure. A finiteelement (FE) method was then applied to analyze the interplay between the microstructure evolution and current density redistribution. A series of 3D FE models was built based on the laminography images for the different testing stages. The current density distribution from the FE analysis indicates that the formation of discrete voids did not affect the global current density distribution until a major coalescence of the voids occurred. The relieving of the global current crowding in the pancake void model was not found in this new EM failure mechanism. It was the local current crowding around individual void found in the new mechanism that is held responsible for the EM retardation. © 2016 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Quantitative X-Ray Microtomography Study of 3-D Void Growth Induced by Electromigration in Eutectic Snpb Flip-Chip Solder Joints

Electromigration Mechanism of Failure in Flip-Chip Solder Joints Based on Discrete Void Formation

Study of electromigration-induced formation of discrete voids in flip-chip solder joints by in-situ 3 D laminography

Study of discrete voids formation in flip-chip solder joints due to electromigration using in-situ 3 D laminography and

Study of Electromigration-Induced Formation of Discrete Voids in Flip-Chip Solder Joints by In-Situ 3D Laminography Observation and Finite-Element Modeling

A new prediction methodology for electromigration-induced solder degradation in a WL-CSP system

Rapid Diagnosis Of Electromigration Induced Failure Time Of Pb-Free Flip Chip Solder Joints By High Resolution Synchrotron Radiation Laminography

In Situ Measurement of Electromigration-Induced Transient Stress in Pb-free Sn–Cu Solder Joints by Synchrotron Radiation Based X-Ray Polychromatic Microdiffraction

Experimental and multiphysics simulation study of atoms migration and morphology evolution in solder joints under high current density

A Molecular Dynamics Investigation of the Micro-Mechanism for Vacancy Formation Between Ag3Sn and Βsn under Electromigration

Comparison of the Time-Dependent Physical Processes in the Electromigration of Deep Submicron Copper and Aluminum Interconnects

Investigation Of Tin Atomic Migration Of Tin-Based Solders With Cluster Model And Dv-X Alpha Method In Electromigration

Coupled Phase Field And Finite Element Modeling Of Void Evolution And Physical Property Change Of Micro Flip-Chip Solder Joints Under Electromigration And Elastic Stress Field

In Situ Synchrotron Study of Electromigration Induced Grain Rotations in Sn Solder Joints

Electromigration of Typical Sn-Based Solder Bump

Electromigration and Thermomigration in Sn3Ag0.5Cu Solder Joints

Numerical Simulations of Migration and Coalescence Behavior of Microvoids Driven by Diffusion and Electric Field in Solder Interconnects

Study of electromigration in Sn-Ag-Cu micro solder joint with Ni interfacial layer

An in-situ experimental and simulation study on the electromigration behavior of SAC305 solder joints

The In-Situ Observation of Grain Rotation and Microstructure Evolution Induced by Electromigration in Sn-3.0Ag-0.5Cu Solder Joints

Experimental Study of Void Formation in Eutectic and Lead-Free Solder Bumps of Flip-Chip Assemblies