Abstract:A frequency-modulated ultrawideband (FM-UWB) hybrid transceiver, with a high system reuse ratio up to 90%, is fabricated in the 65-nm CMOS process for both short-range wireless communication and high-resolution radar ranging. The radio frequency (RF) front-ends (RFFEs) based on module stacking and current reuse achieve significant RF power savings of about 30% and 50% for the transmitter and the receiver (RX), respectively. The presented IF zero-crossing delay discrimination benefits a high radar resolution less than 1 cm. A multimode relaxation oscillator (OSC) for the reconfigured triangular subcarrier generation and a dual-path ring voltage-controlled oscillator (VCO) for the linear FM, stacked by a wideband push–pull power amplifier (PA), generate an FCC-compliant UWB signal. An active balun embedded low-noise amplifier (LNA) and two symmetric-detuning band-passed filters (BPFs) are stacked with the bandwidth extension to linearly demodulate the UWB FM signal. Experimental results show that the 3.75–4.25-GHz hybrid transceiver has an energy efficiency of 1.9 nJ/bit with an active area of 0.7 mm2 and a power dissipation of 1.9 mW and achieves the RX sensitivity of −71 dBm and the transmitted power of −14.1 dBm, with a bit error rate (BER) of 10−4 at a distance of 4 m under the data rate (DR) of 0.1–1.0 Mbps. The transceiver also achieves the noise figure (NF) of 4.8 dB and the phase noise of −78.6 dBc/Hz at 1-MHz offset frequency.

Compact Low-Power CMOS Squarer for High-Speed Noncoherent UWB Receiver

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

A group-selected and gain controllable CMOS active mixer for UWB applications

An IEEE 802.15.4/4z Coherent Quadrature Hybrid Correlation UWB Receiver in 65-nm CMOS

A Low-power Sub-sampler in 0.13 μm CMOS for IR UWB Receiver

A 17.3mW IEEE 802.15.4/4z Coherent Quadrature Hybrid Correlation UWB Receiver in 65nm CMOS

A Low Power 35 Ghz Cmos Uwb Receiver Front-End

A low-power 4.224GS/s sampler in 0.13-μm CMOS for IR UWB receiver

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A 0.13&#x03bc;m CMOS UWB Receiver Front-End Using Passive Mixer

Low-Power Low-Complexity FM-UWB Hybrid Transceiver for Communication and Ranging

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

A non-coherent receiving solution for near field pulse UWB communication

A low data rate FM-UWB transmitter with Δ-Σ based sub-carrier modulation and quasi-continuous frequency-locked loop

A 3–5ghz UWB CMOS Receiver with Digital Control Technique

An 89 Μw MICS/ISM Band Receiver for Ultra-Low-power Applications.

A 1mb/s 3.2&#x2013;4.4ghz Reconfigurable FM-UWB Transmitter in 0.18&#x00b5;m CMOS