Abstract:Summary form only given. Recently, the state-of-the-art of lithium-niobate-on-insulator (LNOI) has been reviewed [1]. In analogy to silicon-on-insulator (SOI), the new material platform for integrated optics with wafers of up to 3” diameter enables the fabrication of optical waveguides with small cross-sections and small bending radii due to the high refractive index contrast. As a consequence, ultra-compact photonic integrated devices such as ring resonators and photonic crystal structures have been developed.Here we demonstrate also Er-doped LNOI, which might become an ideal material for nano-optical amplifiers and lasers. Doping is achieved by pre-diffusion of Er into the upper LN wafer before bonding [2], and the resulting Er concentration is about 1020 cm-3. Ridges of different width w = (2.5 - 10) μm were fabricated on these LNOI substrates (LN thickness of 960 nm) using precision diamond-blade dicing which results in smooth side walls of the fabricated waveguides. We present results of a first investigation of the erbium centers using Raman and fluorescence spectroscopy of planar and ridge waveguides in Er:LNOI.Characterization of the waveguides was performed using Raman and fluorescence spectroscopy. Spectral scans were obtained using a scanning confocal microscope and a 488 nm laser. Besides line broadening that may be attributed to internal strain in the bonded layer, analysis of the Raman spectrum shows no significant difference between the waveguide and the bulk material. However, the erbium emission of the 4H15/2 and 4S3/2 to the 4I15/2 contains several differences in the intensity ratios indicating that the relative transition probabilities are different for the smart cut waveguide. While Raman intensity has a linear relationship with pump power, the intensity of the Er emission starts saturating at pump levels of only a few mW. To investigate fluorescence of the 4I13/2 - 4I15/2 transition inside the formed ridges, a fiber coupled lase- with a wavelength of 980 nm is used for pumping. The rhs of the figure above shows a diced ridge and the green fluorescence that can be observed when the ridge is pumped at 980 nm. An example of the IR fluorescence is given on the right of the above figure using 40 mW of pump light, with the spectrum of an erbium doped fiber as a reference. The emission is broadened and maxima are shifted to longer wavelengths, which may be attributed to defects induced by implantation, re-absorption of fluorescence light, and contributions by amplified spontaneous emission due to the waveguiding effect.

Theoretical study on on-chip gain characteristics of Er 3+ in LiNbO 3 -on-insulator photonic wire pumped at 980 nm wavelength

High-Performance Electro-Optic Modulator on Silicon Nitride Platform with Heterogeneous Integration of Lithium Niobate

2.7 μm mid-infrared Er-doped thin-film LiNbO 3 -on-insulator photonic wire laser

Integrated spiral waveguide amplifiers on erbium-doped thin-film lithium niobate

Highly efficient on-chip erbium-ytterbium co-doped lithium niobate waveguide amplifiers

Efficient erbium-doped thin-film lithium niobate waveguide amplifiers

Single Crystal Erbium Compound Nanowires As High Gain Material for On-Chip Light Source Applications

A short high-gain waveguide amplifier based on low concentration erbium-doped thin-film lithium niobate on insulator

High-gain Erbium Silicate Waveguide Amplifier and a Low-Threshold, High-Efficiency Laser.

A high-gain cladded waveguide amplifier on erbium doped thin-film lithium niobate fabricated using photolithography assisted chemo-mechanical etching

Modeling of optical amplifier waveguide based on silicon nanostructures and rare earth ions doped silica matrix gain media by a finite-difference time-domain method: comparison of achievable gain with Er3+ or Nd3+ ions dopants

On-chip erbium-doped lithium niobate waveguide amplifiers

Judd-Ofelt spectroscopic study of Er:In:LiNbO 3 crystals for integrated optics

A photonic integrated circuit–based erbium-doped amplifier

A photonic integrated circuit based erbium-doped amplifier

Fluorescence in planar and ridge waveguides fabricated in Erbium-Doped lithium-niobate-on-insulator (Er:LNOI)

Erbium-ytterbium codoped thin-film lithium niobate integrated waveguide amplifier with a 27 dB internal net gain

Erbium-ytterbium codoped thin-film lithium niobate integrated waveguide amplifier with 27 dB internal net gain

Controllable Design of Minority Carrier Diffusion in Npn Devices for Enhancing Er3+-Related Electroluminescence

Incorporation of erbium ions into thin-film lithium niobate integrated photonics

Demonstration of Optical Gain at 1535 nm Based on ErIII Complex‐Doped Polymer Waveguides Under Light‐Emitting Diode Excitation