Abstract:The glass transition, crystallization, and melting behaviors of oligomer poly(L-lactide) (PLLA) confined in anodic aluminum oxide (AAO) nanopores were invesitgated by calorimetry. Compared with the bulk counterpart, PLLA located inside AAO nanopores showed frustrated crystallization during the cooling process, and the crystallization enthalpy gradually decreased with the reduction of pore size. In large nanopores, the crystallization peaks of PLLA nanorods were very close to that of bulk sample, which indicated the predomination of heterogeneous nucleation. Meanwhile, the nonisothermal crystallization results displayed that temperature dependence of nucleation rate of PLLA in nanopores was weaker than that in bulk state. As the diameter of nanopore was smaller than 28 nm, the crystallization peak disappeared. The glass state of PLLA nanorods exhibited double glass transition temperatures (T(g)s), the higher Tg( )attributed to chains in the interfacial adsorbed layer adjacent to pore walls, and the lower T-g belonged to chains in the pore center. The two T(g)s showed opposite pore size dependences-the lower one decreased with the reduction of pore size, while the higher one increased. During the heating process, PLLA confined in nanopores showed the pronounced cold crystallization phenomenon, which took place at higher temperatures and the peak was much broader than that of bulk state, which could be ascribed to the supressed nucleation rate, the poor nucleation activity, and the broad nucleation dispersion in PLLA nanorods. Apart form the influence of nucleation, hetergeneous chain mobilities in nanopores also played an important role. Due to the existence of adsorbed layer, surface induced nucleation was hindered. Interestingly, by the nonisothermal crystallization experiments, PLLA chains in the interfacial layer and pore center displayed independent cold crystallization behaviors, and the latter happened at the higher temperatures. Finally, the interfacial effect gradually dominated as the pore size decreased. PLLA crystals formed in small nanopores became unstable, obvious melting-recrystallization phenomena occurred, and the crystallinity and melting temperature of PLLA crystals were lower in smaller nanopores.

Effect of Geometric Curvature on Vitrification Behavior for Polymer Nanotubes Confined in Anodic Aluminum Oxide Templates

Double Glass Transition Temperatures of Poly(Methyl Methacrylate) Confined in Alumina Nanotube Templates

How Thermal Stress Alters the Confinement of Polymers Vitrificated in Nanopores.

Growth of Polymer Nanorods with Different Core–Shell Dynamics Via Capillary Force in Nanopores

Nano-engineering Thermal Transport Performance of Carbon Nanotube Networks with Polymer Intercalation: a Molecular Dynamics Study.

Stabilization of Poly(methyl Methacrylate) Nanofibers with Core–Shell Structures Confined in AAO Templates by the Balance Between Geometric Curvature, Interfacial Interactions, and Cooling Rate

Thermomechanical Coupling in Glassy Polymers: an Effective Temperature Theory

Glass Transition Temperature of Polymer Nanoparticles under Soft and Hard Confinement

Dependences of Confining Size and Interfacial Curvature on the Glass Transition of Polydimethylsiloxane in Self‐Assembled Block Copolymers

Effects of chain ends and densities on the glass transition of polymer thin films probed by linear and cyclic polystyrene

In situ study on bending modulus of Al2O3nanotubes prepared by atomic layer deposition

The glass transition and enthalpy recovery of polystyrene nanorods using Flash differential scanning calorimetry

Physical Aging of Polystyrene Confined in Anodic Aluminum Oxide Nanopores

Unexpected Thermal Annealing Effects On The Viscosity Of Polymer Nanocomposites

Confinement-Induced Deviation of Chain Mobility and Glass Transition Temperature for Polystyrene/Au Nanoparticles

Glass Transitions of Poly(Methyl Methacrylate) Confined in Nanopores: Conversion of Three- and Two-Layer Models

Crystallization of Poly(L-lactide) Oligomer Confined in Alumina Nanopores

Substantial spatial heterogeneity and tunability of glass transition temperature observed with dense polymer brushes prepared by ARGET ATRP

Effect of nanoscale confinement on glass transition of polystyrene domains from self-assembly of block copolymers

Comparing the impact of different adsorbed layers on the local glass transition of polymer matrices

Quantification of interfacial structure at nanoscale and its relationship with viscoelastic glass transition of SiO2/elastomer nanocomposites