Abstract:Here we report an optical fiber sensor capable of performing strain-insensitive simultaneous measurement of bending and temperature using a long-period fiber grating (LPFG) inscribed on doubleclad fiber (DCF) with a CO₂ laser at ˜10.6 μm. The LPFG inscribed on DCF, referred to as a DC-LPFG, was fabricated by scanning CO₂ laser pulses on an unjacketed DCF with a specific period. Due to co-directional mode coupling, the fabricated DC-LPFG has discrete attenuation bands widely distributed over hundreds of nanometers. Among these wavelength-dependent loss dips, adjacent two dips with different resonance wavelengths were selected as sensor indicators for the measurement of bending and temperature. For these two indicator dips designated as dips A and B, their bending and temperature responses were investigated in a curvature range of 4.90 to 21.91 m-1 and a temperature range of 30 to 110 °C. With increasing bending applied to the DC-LPFG at room temperature, dips A and B showed different blue shifts. The bending sensitivities of dips A and B were measured to be approximately -0.77 and 0.51 nm/m-1, respectively. Unlike the bending response, they showed red shifts of different amounts with increasing ambient temperature, while the sensor head (i.e., the DC-LPFG) remained straight without any applied bending. The temperature sensitivities of dips A and B were measured to be ˜0.094 and ˜0.078 nm/°C, respectively. Owing to their linear and independent responses to bending and temperature, bending and temperature changes applied to the DC-LPFG could be simultaneously estimated from the measured wavelength shifts of the two indicator dips using their pre-determined bending and temperature sensitivities. Moreover, in a strain range of 0 to 2200 με (step: 200 με), strain-induced spectral variations of dips A and B were also measured, and the strain sensitivities of dips A and B were evaluated as approximately -0.028 and -0.013 pm/με, respectively. These strain-induced wavelength shifts were so small that they had little effect on the measurement results of bending and temperature. Thus, it is concluded that the fabricated DC-LPFG can be employed as a cost-effective sensor head for strain-insensitive separate measurement of bending and temperature.

High-Sensitivity Strain Sensor Based on Inflated Long Period Fiber Grating

Nanoimprinted Polymer Micro/Nanofiber Bragg Gratings for High-Sensitivity Strain Sensing

Highly Sensitive Strain Sensor Based on a Long-Period Fiber Grating with Chain-Shaped Structure.

Compact Fiber Strain Sensor Fabricated by a CO2 Laser.

Highly Sensitive Long-Period Fiber-Grating Strain Sensor with Low Temperature Sensitivity

Fabrication of Phase-Shifted Long-Period Fiber Grating and Its Application to Strain Measurement

Sensitivity-Enhanced Strain Sensor With a Wide Dynamic Range Based on a Novel Long-Period Fiber Grating

In-Fiber Grating Fabricated by Femtosecond Laser Direct Writing for Strain Sensing

High Sensitivity Strain Sensor Based on Curved LPG Fabricated in Eccentric Hollow-Core Fiber

High-sensitivity Strain Sensor with an In-Fiber Air-Bubble Fabry-Perot Interferometer

All-Fiber Strain Sensor Based on Dual Side V-Grooved Long-Period Fiber Grating

A compact fiber-based sensor for wide range strain measurement

Strain and Temperature Characteristics of a Long-Period Grating Written in a Photonic Crystal Fiber and Its Application as a Temperature-Insensitive Strain Sensor

A Novel High-Sensitivity Fiber Grating Sensor for Simultaneous Measurement of Temperature and Pressure

Highly Integrated All-Fiber FP/FBG Sensor for Accurate Measurement of Strain under High Temperature

A Long-Period Fiber Grating Sensor Based on a Core-Cladding Misalignment Structure

High-Sensitivity Strain and Temperature Simultaneous Measurement Sensor Based on Multimode Fiber Chirped Long-Period Grating

Temperature self-compensation strain sensor based on cascaded concave-lens-like long-period fiber gratings

Strain-Insensitive Simultaneous Measurement of Bending and Temperature Using Long-Period Fiber Grating Inscribed on Double-Clad Fiber with CO₂ Laser

Deeply-Tapered Ultrashort Long-Period Fiber Grating and Its Application to Ultrasensitive Transverse-Load Sensor

High sensitivity fiber optic strain sensor based on CFBG-FPI and vernier effect