Acid-pretreated red mud for selective catalytic reduction of NO with NH3: Insights into inhibition mechanism of binders

Bin Wang,Jun Ma,Dong Wang,Zhiqiang Gong,Qinglong Shi,Chuan Gao,Chunmei Lu,John Crittenden

DOI: https://doi.org/10.1016/j.cattod.2020.05.036

IF: 5.3

2021-09-01

Catalysis Today

Abstract:Recently, we proposed an efficient pretreatment method for waste red mud (RM) to be utilized as an SCR catalyst. However, in terms of the shaping process, RM’s hydraulicity and easily pulverization always cause the loss of surface areas and active species, which limits its application. In this study, we prepared shaped RM catalysts using the sesbania powder (sp), guar gum (gg), and carboxymethylcellulose sodium (cs) to investigate the impact of binders on the RM catalysts. The results exhibited that the RM-15sp-550 showed the highest activity with T90 (the reaction temperature with NO x conversions higher than 90%) active window of 325–450 °C. The gg and cs strongly inhibited the surface reducibility and NH3 adsorption, which was caused by the decrease of the Fe(III), absorbed oxygen, and acid sites (especially the Brönsted acid sites). The reactions between adsorbed ammonia species on the Brönsted acid sites and gaseous NO were restricted on the RM-15gg-500 and RM-15cs-500. Compared with the RM-15gg-500 and RM-15cs-500, the RM-15sp-500 exhibited more accumulated pores. Raman experiments proposed that more oxygen vacancies formed on the RM-15sp-500 and NH3 were selectively chemisorbed on the FeTiO3 during the NH3 presorbing process, which benefited SCR reaction. The strong viscosity at low temperatures and low decompose temperature of the sp minimized its impact on the RM catalyst. This made it an excellent binder for industrial RM catalyst. The cost analysis showed that the price of the RM catalyst was 67% lower than that of commercial V-W-Ti catalyst, and the use of RM catalyst can also alleviate the RM accumulation issue.

chemistry, physical,engineering, chemical, applied

What problem does this paper attempt to address?

### Problems Addressed by the Paper

This paper aims to address the issues associated with using red mud (RM) as a selective catalytic reduction (SCR) catalyst. Specifically:

1. **Utilization of Red Mud**:
- Red mud is a harmful waste product generated during alumina production, with high alkalinity (pH 10-12), posing environmental hazards.
- Through acid pretreatment, red mud can be used as an SCR catalyst, but its tendency to pulverize and hydraulicity leads to the loss of surface active sites during the forming process.

2. **Impact of Forming Aids**:
- Forming aids (such as guar gum, sodium carboxymethyl cellulose, etc.) significantly affect the performance of red mud catalysts.
- These aids may inhibit surface reducibility and ammonia adsorption capacity, thereby affecting catalyst activity.

3. **Selection of Different Aids**:
- By comparing the effects of different aids (such as sesbania powder, guar gum, sodium carboxymethyl cellulose) on red mud catalysts, the best aid can be identified to enhance the activity and stability of the catalyst.

4. **Cost Analysis**:
- The study examines the cost of red mud catalysts, demonstrating their significant cost advantage over commercial vanadium-tungsten-titanium (V-W-Ti) catalysts and helping to alleviate the red mud accumulation problem.

In summary, this paper aims to find a low-cost and efficient aid to enhance the application potential of red mud as an SCR catalyst by studying the effects of different aids on the performance of red mud catalysts.