Abstract:The method of ICP-OES for the direct determination of high content of rubidium in rubidium chloride solutions was studied through mass dilution method and optimizing parameters of the instrument in the present paper. It can reduce the times of dilution and the error introduced by the dilution, and improve the accuracy of determination results of rubidium. Through analyzing the sensitivity of the three detection spectral lines for rubidium ion, linearly dependent coefficient and the relative errors of the determination results, the spectral line of Rb 780.023 nm was chosen as the most suitable wavelength to measure the high content of rubidium in the rubidium chloride solutions. It was found that the instrument parameters of ICP-OES such as the atomizer flow, the pump speed and the high-frequency power are the major factors for the determination of rubidium ion in the rubidium chloride solutions. As we know instrument parameters of ICP-OES have an important influence on the atomization efficiency as well as the emissive power of the spectral lines of rubidium, they are considered as the significant factors for the determination of rubidium. The optimization parameters of the instrument were obtained by orthogonal experiments and further single factor experiment, which are 0.60 L . min(-1) of atomizer flow, 60 r . min(-1) of pump speed, and 1 150 W of high-frequency power. The same experiments were repeated a week later with the optimization parameters of the instrument, and the relative errors of the determination results are less than 0.5% when the concentration of rubidium chloride ranged from 0.09% to 0.18%. As the concentration of rubidium chloride is 0.06%, the relative errors of the determination results are 1.7%. The determination of lithium chloride and potassium chloride in the high concentration of the aqueous solutions was studied under the condition of similar instrument parameters. It was found by comparison that the determination results of lithium chloride are better than that of potassium chloride and rubidium chloride. The method of ICP-OES used for determination of high content of rubidium is fast and simple for operation, and the results are accurate. It is suitable for studying the equilibrium in the salt-water system containing rubidium and for analysis of products of rubidium with high content.

Determination of High Concentrations of Rubidium Chloride by Icp-Oes

Preferential extraction of rubidium from high concentration impurity solution by solvent extraction and preparation of high-purity rubidium salts

Determination of 14 trace rare earth impurities in high-purity CeO2 by inductively coupled plasma mass spectrometry with membrane desolvation

Rapid Determination Of Trace Iodine In Oilfield Brine Based On Oxidation-Atomic Emission Spectrometry

Determination of iodine species in seaweed and seawater samples using ion-pair reversed phase high performance liquid chromatography coupled with inductively coupled plasma mass spectrometry

Simultaneous Determination of Rare Earth Elements in Aqueous Samples by Online Preconcentration System and Inductively Coupled Plasma Mass Spectrometry

Determination of Rare Earth Elements in Trialkyl Phoshine Oxide(TRPO)-Kerosene by ICP-AES

ICP-OES Determination of trace Ga,In,Bi,Sn and Pb preconcentrated by macroporous poly(vinylethylenediamine) chelating resin

Extraction of rubidium ion from brine solutions by dicyclohexano-18-crown-6 / ionic liquid system

Determination of Iodine Species by Ion Chromatography with Inductively Coupled Plasma Mass Spectrometry

Investigation on pretreatment method for the determination of rare earth elements in polymetallic mineral samples in Pan-Xi region by ICP-MS

Copper Ion Assisted Photochemical Vapor Generation of Chlorine for Its Sensitive Determination by Sector Field Inductively Coupled Plasma Mass Spectrometry.

Determination of trace rare earth elements by inductively coupled plasma optical emission spectrometry after preconcentration with immobilized nanometer titanium dioxide

Electrochemical Studies on a Zirconium Hexacyanoferrate Modified Electrode and Utility for the Determination of Rubidium

Elimination of the Spectral Interference from Polyatomic Ions with Rare Earth Elements in Inductively Coupled Plasma Mass Spectrometry by Combining Algebraic Correction with Chromatographic Separation

Determination of halogens in organic compounds by high resolution inductively coupled plasma mass spectrometry (HR-ICP-MS)

Separation of Cesium and Rubidium from Solution with High Concentrations of Potassium and Sodium

[Determination of Heavy Metals for RoHS Compliance by ICP-OES Spectrometry Coupled with Microwave Extraction System].

Accurate Determination of Non-Metallic Impurities in High Purity Tetramethylammonium Hydroxide Using Inductively Coupled Plasma Tandem Mass Spectrometry

Determination Of Sulfate In Coastal Salt Marsh Sediments With High-Chloride Concentration By Ion Chromatography: A Revised Method

The Determination of 52 Elements in Marine Geological Samples by an Inductively Coupled Plasma Optical Emission Spectrometry and an Inductively Coupled Plasma Mass Spectrometry with a High-Pressure Closed Digestion Method