Abstract:Coagulation plays an important role in effectively alleviating ultrafiltration (UF) membrane fouling due to the existence of flocs. In comparison to traditional filtration, direct filtration (no sedimentation tank) is generally considered to result in less membrane fouling due to the looser cake layer formed on the membrane surface. However, cake layer characteristics are easily influenced by operating conditions (e.g., sedimentation time, temperature), resulting in different fouling loads and the still very limited knowledge about the fouling behavior. Here, a detailed investigation of UF membrane performance was carried out to analyze the differences between traditional filtration and direct filtration. The results showed that a critical settling time indeed existed when flocs gradually settled, leading to severe membrane fouling induced by a dense and thick cake layer. Therefore, the traditional filtration performed worse when the settling time was shorter than the critical time, while it performed better when the settling time was longer. In comparison to room temperature water, the proportion of membrane fouling caused by the cake layer increased at low water temperature due to the contracted membrane pore size, and the cake layer thickness became the main fouling load. The longer the settling time, the fewer pollutants reached the membrane surface, the thinner the cake layer, and the lower the potential for membrane fouling. Thus, traditional filtration performed better than direct filtration, and the critical settling time was not obvious. Although solution pH played an important role in floc properties, the fouling load was influenced little and traditional filtration still performed better. This work shows that the cake layer properties/fouling loads vary with the settling time during the coagulation-UF process, and this finding is of great significance to the improvement of membrane technology in drinking water plants.

Floc properties and membrane fouling of polyferric silicate chloride and polyferric chloride: the role of polysilicic acid

Enhanced Coagulation-Flocculation Performance of Iron-Based Coagulants: Effects of PO4(3-) and SiO3(2-) Modifiers

Novel ferromagnetic nanoparticle composited PACls and their coagulation characteristics.

Cancer in pregnancy: Motherisk on-line question and answer forum.

Study on the preparation of polysilicate ferric flocculant and its treatment of high turbidity tailings water

Improved Ultrafiltration Performance Through Dielectric Barrier Discharge/sulfite Pretreatment: Effects of Water Matrices and Mechanistic Insights

Characterization and coagulation–flocculation performance of a composite coagulant: poly-ferric-aluminum-silicate-sulfate

Using inorganic coagulants to control membrane fouling in a submerged membrane bioreactor

[Analysis of reaction process between Si and Fe in poly-silicic-ferric sulfate (PSF) coagulant]

Properties of polyferric-silicate-sulfate(PFSS) coagulant

Study on Preparation and Flocculation Properties of Inorganic Polymer Flocculant Polyferric Silicate Sulfate (Pfss)

New insights into membrane fouling in coagulation-ultrafiltration by cake characteristics analysis: A case study with PACl-Al13 and PACl

Quantitative Assessment of Interfacial Interactions Governing Ultrafiltration Membrane Fouling by the Mixture of Silica Nanoparticles (SiO2 NPs) and Natural Organic Matter (NOM): Effects of Solution Chemistry

The Production and Application of Complex Flocculant Polysilicate Aluminium Ferric(PSAF)

Optimized coagulation pretreatment alleviates ultrafiltration membrane fouling: The role of floc properties and slow-mixing speed on mechanisms of chitosan-assisted coagulation

Insight into the influence of humic acid and sodium alginate fractions on membrane fouling in coagulation-ultrafiltration combined system

Study on the flocculation condition of Poly-Silicate-Aluminum-Ferric (PSiAF) coagulant prepared with coal gangue as raw material

Influence of Sedimentation with Pre-Coagulation on Ultrafiltration Membrane Fouling Performance.

Application of AFM in anti-fouling performance analysis of PVDF/SiO2 blending ultrafiltration membranes

Direct preparation of polysilicic acid flocculant by using pickling waste liquor of metal plate

Insight into Control Mechanism of Polymeric Ferric Titanium Composite Coagulant on Membrane Fouling: Role of Natural Organic Matters