Abstract:Self-mixing interferometry (SMI) is suitable to sense and measure vibrations of amplitudes ranging from picometers to millimeters at frequencies from sub-Hz to MHz’s. As an optical probe, SMI has the advantage of being non-invasive with the ability to measure without any treatment of the target surface and operate from a substantial standoff distance from the target. As an additional advantage, the SMI configuration is much simpler than that of conventional interferometers as it does not require any optical part external to the laser source. After a short introduction to the basics of SMI, we review the development of configurations of SMI instruments for vibration measurements, based on both analog and digital processing, with record performance to cover the range of vibration amplitudes from 0.1 nm to 1 mm, frequencies up to MHz, and stand-off distances up to 100 m. These performances set a benchmark that is unequaled by other approaches reported so far in the literature. The configurations we describe are (i) a simple MEMS-response testing instrument based on fringe counting, (ii) a half-fringe locking vibrometer for mechanical mode analysis and transfer function measurements, with a wide linear response on six decades of amplitude, (iii) a vibrometer with analog switching cancellation for μm-to-mm amplitude of vibrations, and (iv) a long standoff distance vibrometer for testing large structures at distances up to 100 m and with nm sensitivity. Lastly, as the vibrometer will almost invariably operate on untreated, diffusing surfaces, we provide an evaluation of phase-induced speckle pattern errors affecting the SMI measurement.

Simultaneous Measurement of Vibration and Parameters of a Semiconductor Laser Using Self-Mixing Interferometry

Modified Homodyne Laser Interferometer Based on Phase Modulation for Simultaneously Measuring Displacement and Angle.

Laser self-mixing interferometry for dynamic displacement sensing of multiple targets

Multiple Self-Mixing Interferometry Based on Lock-in Amplifier Analysis for Vibration Measurement

Laser Self-Mixing Sensor for Simultaneous Measurement of Young's Modulus and Internal Friction (Invited)

Laser Self-Mixing Sensor for Simultaneous Measurement of Young’s Modulus and Internal Friction (Invited)

Experimental study of self-mixing vibration measurement using VCSELs

Self-Mixing Interferometry Cooperating with Frequency Division Multiplexing for Multiple-Dimensional Displacement Measurement

All-Fiber Laser-Self-Mixing Sensor for Acoustic Emission Measurement

Self-mixing velocimeter using an edge emitting laser

Enhanced precision in angular measurement through all-fiber laser self-mixing interferometry

Quadrature-Phase Detection of Laser SMI Based on Square-Wave Modulation for Displacement Measurement

Optimization of the Laser Vibrometer Based on the Self-Mixing Effect in a Diode Laser

Displacement Sensing for Laser Self-Mixing Interferometry by Amplitude Modulation and Integral Reconstruction

Improving the measurement performance for a self-mixing interferometry-based distance and velocity sensing system using VMD

Laser Self-Mixing Interference Displacement Measurement Based on VMD and Phase Unwrapping

All-fiber Hybrid Displacement-Sensing System Based on Self-Mixing Interference and Intracavity Spectroscopy

Rotation Angle Measurement Method Based on Self-Mixing Interference of a Fiber Laser

Vibration Measurements by Self-Mixing Interferometry: An Overview of Configurations and Benchmark Performances

Self-mixing Interferometry Based on Nanometer Fringes and Polarization Flipping

A fast and cost-efficient technique for estimating feedback strength parameter C in laser self-mixing interferometry