Abstract:We report a systematic study on the effect of molecular weight (MW) on microphase separation of mixed poly(tert-butyl acrylate) (PtBA)/polystyrene (PS) brushes grafted on 172 nm silica particles. The brushes were synthesized by sequential surface-initiated atom transfer radical polymerization (ATRP) of tBA at 75 degrees C and nitroxide-mediated radical polymerization (NMRP) of styrene at 120 degrees C from silica particles functionalized with an asymmetric difunctional initiator bearing an ATRP initiator and an NMRP alkoxyamine. The MWs of the two polymers in each sample were controlled to be similar to each other. A series of mixed brush samples with different average MWs, from 13.8 to 33.1 kDa, but comparable overall grafting densities were made, and their microphase separation was studied by transmission electron microscopy (TEM). The TEM samples were prepared by drop-casting the dispersions of mixed brush-grafted particles in CHCl3 and also in water (stabilized by a surfactant) and staining the brushes with RuO4. While CHCl3 is a good solvent for both PtBA and PS, making the brushes spread out on the carbon films of TEM grids, water is a nonselective poor solvent for the two polymers, causing the brushes to collapse uniformly on silica core. All samples exhibited lateral microphase separation, forming nearly bicontinuous rippled nanopatterns. The average ripple wavelength D increased with increasing the MW. For samples directly cast from chloroform, D scaled with MW0.70 in the studied MW range. For uniformly collapsed mixed brushes cast from water, D was proportional to MW0.56. The latter is close to the theoretical prediction of D similar to MW0.5 for perfect Y-shaped brushes in the melt and in nonselective poor solvents. We further compared the phase separation of mixed PtBA/PS brushes grafted on silica particles and PtBA-b-PS diblock copolymers and found that the microphase separation of mixed brushes was weaker than that of diblock copolymers.

Effect of the Molecular Weight on Deformation States of the Polystyrene Film by AFM Single Scanning.

Rheology of Ultra High Molecular Weight Polystyrene

Direct Measurement of Plowing Friction and Wear of a Polymer Thin Film Using the Atomic Force Microscope

Molecular Dynamics Simulation of Form Measurement Process of Soft Materials Using Atomic Force Microscope

A Steered Molecular Dynamcs Study of Adsorbed Polymer Chains

Study of Elastic Modulus and Yield Strength of Polymer Thin Films Using Atomic Force Microscopy

Investigating Mechanical Response of Single Chain Polystyrene Particles by Scanning Probe Techniques

Deformation Mechanisms of Polymer Thin Films by Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress. Part Iii: Influence of Morphology on Molecular Orientation of Isotactic Polypropylene Films Subjected to Uniaxial Stretching

Investigation of the Nanoscale Elastic Recovery of A Polymer Using an Atomic Force Microscopy-Based Method

Surface Interactions Surpass Carbon-Carbon Bond: Understanding and Control of the Scission Behavior of Core-Shell Polymer Brushes on Surfaces.

Segmental Orientations and Deformation Mechanism of Poly(Ether-Block-Amide) Films

Interfacial Characteristics Of Amorphous Polystyrene And Binary Polymer Blend Thin Films Based On Scanning Force Microscopy

Morphologies in Acetone-Annealed Polystyrene-Poly(Methyl Methacrylate) Diblock Copolymer Thin Films

Deformation and Molecular Orientation in Films of Metallocene Polypropylene, Ethylene-Butylene Rubber, and Their 80/20 (W/W) Blend Revealed by the Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism, Macroscopic Stress, and Mesoscale Strain

Influences of Substrate Adhesion and Particle Size on the Shape Memory Effect of Polystyrene Particles.

Effect of Molecular Weight on Lateral Microphase Separation of Mixed Homopolymer Brushes Grafted on Silica Particles

Dispersity effects on phase behavior and structural evolution in ultrathin films of a deuterated polystyrene-block-poly(methyl methacrylate) diblock copolymer

Probing Polymer Deformation Profiles at Varying Depths in Nanoimprint Lithography

Deformation Behavior of Microparticle-Based Polymer Films Visualized by AFM Equipped with a Stretching Device

Deformation induced changes in surface properties of polymers investigated by scanning force microscopy

Size Dependent Mechanical Properties of Monolayer Densely Arranged Polystyrene Nanospheres.