Abstract:Flow injection (FI) sample introduction was coupled with a recently developed atomic emission source, the microwave plasma torch (MPT), operating at 200 W with Ar as the plasma gas. The use of FI in conjunction with an ultrasonic nebulizer was compared with direct nebulization; parameters taken into consideration include carrier solution flow-rate, aerosol carrier gas flow-rate, sample volume, dispersion coefficients and the effect of two easily ionized concomitant elements. Detection limits and precision of the FI technique were assessed for four sample-loop volumes: 75, 200, 250, and 500 μl. Flow injection was found to offer several advantages over continuous sample introduction: rapid sample throughput and a reduction of memory effects without a loss in sensitivity or precision. Furthermore, by appropriate choice of sample dispersion, a significant reduction of the Na and K interferences can be achieved without a substantial deterioration in sensitivity. An FI system incorporating a microcolumn of bonded silica with octadecyl functional groups was used to determine Cu in synthetic sea water. The sample preconcentration time was one minute at a sample solution flow-rate of 1.0 ml min−1; pure ethanol was used as the eluent. The detection capability in this preconcentration mode was approximately 25 times better than that offered by a comparable continuous nebulization system. The detection limit for Cu was 0.16 ng ml−1, the relative standard deviation at 500 ng ml−1 was about 3.2%, and recovery rates were in the 94–97% range.

Hyphenation of Flow Injection/Sequential Injection with Chemical Hydride/Vapor Generation Atomic Fluorescence Spectrometry

Trends and perspectives of flow injection/sequential injection on-line sample-pretreatment schemes coupled to ETAAS

New Developments in Flow Injection Vapor Generation Atomic Absorption Spectrometry

New Developments in Flow Injection/Sequential Injection On-line Separation and Preconcentration Coupled with Electrothermal Atomic Absorption Spectrometry for Trace Metal Analysis

On-line Separation and Preconcentration in Flow Injection Analysis

Trends of Flow Injection Sample Pretreatment Approaching the New Millennium

Direct Processing and Analysis of Solid and Other Complex Samples with Automatic Flow Injection Systems

Flow Injection–electrochemical Hydride Generation Technique for Atomic Absorption Spectrometry. Invited Lecture

On-line sample-pre-treatment schemes for trace-level determinations of metals by coupling flow injection or sequential injection with ICP-MS

Recent Advances in Hyphenation of Nanoflow Liquid Phase Separation with Inductively Coupled Plasma Mass Spectrometry

The Third Generation of Flow Injection Analysis:Current Situation and Perspectives of Lab-on-Valve Scheme

New Developments in Flow Injection Separation and Preconcentration Techniques for Electrothermal Atomic Absorption Spectrometry

Combination of Flow-Injection Techniques with Atomic Spectrometry in Agricultural and Environmental Analysis

Liquid Chromatography Hydride Generation Atomic Fluorescence Spectrometry for Arsenic Speciation III. A Novel Pipelines Connect Technique of Pretreatment System

Study and Application of Flow Injection Liquid-Liquid Extraction Non-Aqueous Media Mercury Reduction Atomic Fluorescence Spectrometry

Flow Injection Atomic Absorption Spectrometry

Recent Advance of Hydride Generation–Analytical Atomic Spectrometry: Part I—Technique Development

Flow injection on-line solid phase extraction for ultra-trace lead screening with hydride generation atomic fluorescence spectrometry.

Liquid Chromatography Hydride Generation Atomic Fluorescence Spectrometry for Arsenic Speciation Analysis I. Optimization Method of Instrument Parameters and Theoretical Interpretation

Evaluation of flow-injection techniques for microwave plasma torch atomic emission spectrometry

New Applications of Flow Injection Micro-column On-line Preconcentration Coupled with Atomic Spectrometry