Evaluation of flow-injection techniques for microwave plasma torch atomic emission spectrometry

Yolanda Madrid,Min Wu,Qinhan Jin,Gary M. Hieftje

DOI: https://doi.org/10.1016/0003-2670(93)85083-V

IF: 6.911

1993-01-01

Analytica Chimica Acta

Abstract:Flow injection (FI) sample introduction was coupled with a recently developed atomic emission source, the microwave plasma torch (MPT), operating at 200 W with Ar as the plasma gas. The use of FI in conjunction with an ultrasonic nebulizer was compared with direct nebulization; parameters taken into consideration include carrier solution flow-rate, aerosol carrier gas flow-rate, sample volume, dispersion coefficients and the effect of two easily ionized concomitant elements. Detection limits and precision of the FI technique were assessed for four sample-loop volumes: 75, 200, 250, and 500 μl. Flow injection was found to offer several advantages over continuous sample introduction: rapid sample throughput and a reduction of memory effects without a loss in sensitivity or precision. Furthermore, by appropriate choice of sample dispersion, a significant reduction of the Na and K interferences can be achieved without a substantial deterioration in sensitivity. An FI system incorporating a microcolumn of bonded silica with octadecyl functional groups was used to determine Cu in synthetic sea water. The sample preconcentration time was one minute at a sample solution flow-rate of 1.0 ml min−1; pure ethanol was used as the eluent. The detection capability in this preconcentration mode was approximately 25 times better than that offered by a comparable continuous nebulization system. The detection limit for Cu was 0.16 ng ml−1, the relative standard deviation at 500 ng ml−1 was about 3.2%, and recovery rates were in the 94–97% range.