Abstract:Oxidative stability of radiation crosslinked ultrahigh molecular weight polyethylene (UHMWPE) artificial joints is significantly improved by vitamin E (VE), but there is a dilemma that VE hinders crosslinking and thus jeopardizes the wear of UHMWPE. In this effort, we proposed an efficient strategy to stabilize UHMWPE under limited antioxidant contents, where VE and D-sorbitol (DS) were used as the primary antioxidant and the secondary antioxidant respectively. For non-irradiated blends with fixed antioxidant contents, oxidative stability accessed by oxidation induction time (OIT) of VE/DS/UHMWPE blends was superior to that of VE/UHMWPE blends, while DS/UHMWPE blends showed no increase in OIT. The cooperation between DS and VE exhibited a synergistic effect on enhancing the oxidative stability of UHMWPE. Interestingly, the irradiated VE/DS/UHMWPE blends showed comparable OIT but a significantly higher crosslink density than the irradiated VE/UHMWPE blends. The crystallinity, melting point, and in vitro biocompatibility of the blends were not affected by VE and DS. The quantitative relationships of mechanical properties, oxidation stability, crystallinity and crosslink density were established to unveil the correlation of these key factors. The overall properties of VE/UHMWPE and VE/DS/UHMWPE blends were compared to elucidate the superiority of the antioxidant compounding strategy. These findings provide a paradigm to break the trade-off between oxidative stability, crosslink density and mechanical properties, which is constructive to develop UHMWPE bearings with upgraded performance for total joint replacements.Statement of SignificanceVE-stabilized UHMWPE is the most commonly used material in total joint replacements at present. However, oxidation and wear resistance of VE/UHMWPE implants cannot be unified since VE reduces the efficiency of radiation crosslinking. It limits the use of VE. Herein, we proposed a compounding stabilization by the synergy between VE and DS. The antioxidation capability of VE was revived by DS, thus enhancing the oxidation stability of unirradiated UHMWPE. The irradiated VE/DS/UHMWPE exhibited similar oxidation stability but higher crosslink density than irradiated VE/UHMWPE, which is beneficial to combat wear of UHMWPE and to inhibit the occurrence of osteolysis. This synergistic antioxidation strategy endows the UHMWPE joint material with good overall performance, which is of clinical significance.

Strain-Induced Crystallization and Orientation of Vitamin E-Blended Ultrahigh Molecular Weight Polyethylene

813 the Performances of Vitamin E (D, L-α-Tocopherol) Added Ultra High Molecular Weight Polyethylene for Artificial Knee Components

1227 the Effect of Vitamin E (D, L-α-Tocopherol) Addition on Microscopic Mechanical Behavior of Ultra High Molecular Weight Polyethylene

Effects of vitamin E blending on plastic deformation mechanisms of highly crosslinked ultrahigh molecular weight polyethylene (HXL-UHMWPE) in total hip arthroplasty.

Strain-induced Microstructural Rearrangement in Ultra-High Molecular Weight Polyethylene for Hip Joints: A Comparison Between Conventional and Vitamin E-infused Highly-Crosslinked Liners.

A comparative microstructural study of vitamin-E blended and infused highly crosslinked UHMWPE for total knee arthroplasty.

Vitamin-E blended and infused highly cross-linked polyethylene for total hip arthroplasty: a comparison of three-dimensional crystalline morphology and strain recovery behavior.

Effect of Surface Crosslinking on the Wear and Friction Behavior of Tea Polyphenol Stabilized Ultra-High Molecular Weight Polyethylene for Total Joint Replacements

Effect of surface crosslinking on the Friction behavior of Tea Polyphenol stabilized Ultra-high molecular weight polyethylene

ON THE PHYSICAL AND STRUCTURAL EFFECTS OF VITAMIN-E BLENDING IN HIGHLY CROSS-LINKED POLYETHYLENE FOR TOTAL HIP ARTHROPLASTY

Strain in UHMWPE for Orthopaedic Use Studied by Raman Microprobe Spectroscopy.

High temperature melted, radiation cross-linked, vitamin E stabilized oxidation resistant UHMWPE with low wear and high impact strength

Vitamin E Can Be Used to Hinder Scissioning in Radiation Cross-Linked Uhmwpe During High-Temperature Melting

Mechanisms of plastic deformation in highly cross-linked UHMWPE for total hip components--the molecular physics viewpoint.

Deformation and Molecular Orientation in Films of Metallocene Polypropylene, Ethylene-Butylene Rubber, and Their 80/20 (W/W) Blend Revealed by the Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism, Macroscopic Stress, and Mesoscale Strain

Synergy between vitamin E and D-sorbitol in enhancing oxidation stability of highly crosslinked ultrahigh molecular weight polyethylene

Enhanced Oxidation Stability of Highly Cross-Linked Ultrahigh Molecular Weight Polyethylene by Tea Polyphenols for Total Joint Implants.

Vitamin E-stabilized UHMWPE: Biological response on human osteoblasts to wear debris

Synergy Stabilization of Vitamin E and D-sorbitol on Crosslinked Ultrahigh Molecular Weight Polyethylene for Artificial Joint under In-Vitro Clinically Relevant Accelerated Aging

Impact resistance and fractography in ultra high molecular weight polyethylenes

Use of vitamin E to protect cross-linked UHMWPE from oxidation