Abstract:Printhead heating is implemented during aerosol jet printing to drive aerosol‐phase drying, supporting higher throughput fabrication with minimal change in resolution. This reduces process sensitivity, provides an effective and independent control to tailor print characteristics that generalizes to different inks, and is particularly useful for challenging print requirements such as conformal and high aspect ratio patterning. Aerosol jet printing offers high resolution, broad materials compatibility, and digital patterning for flexible, conformal, and hybrid electronics. However, limited throughput, instability, and complex optimization requirements inhibit translation to industrial applications. An in‐line heater integrated on a custom printer is demonstrated to modulate droplet evaporation in the aerosol phase, thereby decoupling the deposition rate of functional solids and liquid ink to enable taller, narrower features with aspect ratios reaching 0.29 for a single line. Heating the printhead from room temperature to 80 °C reduced the sensitivity of resolution to deposition rate by ≈90%, improving reliability. With this strategy, increasing the linear deposition rate by 10x results in a modest increase of 27% in line width, compared to a four‐fold increase without heating, permitting higher throughput without sacrificing print quality. Providing a control for in‐line drying independent of ink formulation enables rapid, straightforward design of new materials and processes. This ability to engineer drying of droplets prior to impingement provides a versatile tool to meet complex fabrication challenges, as demonstrated here for both high aspect ratio printing and conformal patterning on rough and three‐dimensional surfaces.

Characteristics of carbon nanotube based micro-bubble generators for thermal jet printing

Leveraging 3D Printing for the Design of High-Performance Venturi Microbubble Generators

Inkjet Printhead Arrays with No Separating Wall Between Bubbles

Characteristics of Carbon Nanotube Nanofluid and Heat Transfer in Gravity Heat Pipe

Fabrication and electrical characteristics of carbon nanotube-based microcathodes for use in a parallel electron-beam lithography system

Design and Fabrication of Monolithic Multidimensional Data Registration Cmos/Mems Ink-Jet Printhead

Microheater Chips with Carbon Nanotube Resistors

Vorticity-induced flow-focusing leads to bubble entrainment in an inkjet printhead: synchrotron X-ray and volume-of-fluid visualizations

Design and Fabrication of A Piezoelectric Bend Mode Drop-On-Demand Inkjet Printhead with Interchangeable Nozzle

The Preparation and Properties of Microheater Based on Graphene Oxide and Micro/Nanofiber

Numerical modeling and analysis of coaxial electrohydrodynamic jet printing

Enhanced Resolution, Throughput, and Stability of Aerosol Jet Printing via In Line Heating

Quantitative Thermal Imaging of Single-Walled Carbon Nanotube Devices by Scanning Joule Expansion Microscopy.

A Simple Method for Fabricating Ink Chamber of Inkjet Printheads

Novel Microfluid Actuator Based On Marangoni Effect

Multi-dimensional Data Registration CMOS/MEMS Integrated Inkjet Printhead

Carbon Nanocoil-Based Photothermal Conversion Carrier for Microbubble Transport

Preparing Two-Dimensional Nano-Catalytic Combustion Patterns Using Direct Inkjet Printing

Carbon dioxide bubble-propelled microengines in carbonated water and beverages.

Carbon Nanotube Ink Dispersed by Chitin Nanocrystals for Thermoelectric Converter for Self‐Powering Multifunctional Wearable Electronics

Preparation of water-based carbon nanotube inks and application in the inkjet printing of carbon nanotube gas sensors