Abstract:Printhead heating is implemented during aerosol jet printing to drive aerosol‐phase drying, supporting higher throughput fabrication with minimal change in resolution. This reduces process sensitivity, provides an effective and independent control to tailor print characteristics that generalizes to different inks, and is particularly useful for challenging print requirements such as conformal and high aspect ratio patterning. Aerosol jet printing offers high resolution, broad materials compatibility, and digital patterning for flexible, conformal, and hybrid electronics. However, limited throughput, instability, and complex optimization requirements inhibit translation to industrial applications. An in‐line heater integrated on a custom printer is demonstrated to modulate droplet evaporation in the aerosol phase, thereby decoupling the deposition rate of functional solids and liquid ink to enable taller, narrower features with aspect ratios reaching 0.29 for a single line. Heating the printhead from room temperature to 80 °C reduced the sensitivity of resolution to deposition rate by ≈90%, improving reliability. With this strategy, increasing the linear deposition rate by 10x results in a modest increase of 27% in line width, compared to a four‐fold increase without heating, permitting higher throughput without sacrificing print quality. Providing a control for in‐line drying independent of ink formulation enables rapid, straightforward design of new materials and processes. This ability to engineer drying of droplets prior to impingement provides a versatile tool to meet complex fabrication challenges, as demonstrated here for both high aspect ratio printing and conformal patterning on rough and three‐dimensional surfaces.

Design and Fabrication of Monolithic Multidimensional Data Registration Cmos/Mems Ink-Jet Printhead

Multi-dimensional Data Registration CMOS/MEMS Integrated Inkjet Printhead

The 3d Multiplexer Data Registration Architecture for High Performance Inkjet Printhead

An Intelligent High-Speed 3D Data Registration Integrated Circuit Applied to Large Array Format Inkjet Printhead

Reduced 30% scanning time 3D multiplexer integrated circuit applied to large array format 20KHZ frequency inkjet print heads

Three-Dimensional Architecture of Multiplexing Data Registration Integrated Circuit for Large-Array Ink Jet Printhead

Design and Fabrication of A Piezoelectric Bend Mode Drop-On-Demand Inkjet Printhead with Interchangeable Nozzle

Fabrication and Evaluation of a Protruding Si-based Printhead for Electrohydrodynamic Jet Printing

Design and simulation of electrostatic inkjet head

A Novel High-Dpi and Monodisperse Droplet Inkjet Printhead with the Piezoelectric Cutter

High Density, Addressable Electrohydrodynamic Printhead Made of a Silicon Plate and Polymer Nozzle Structure

A Thermal Ink-Jet Printer Head Prototype with Full Carbon Based Microbubble Generator

Design and simulation of a hybrid inkjet printhead for ejecting high viscous inks

Design and Fabrication of a PET/PTFE-based Piezoelectric Squeeze Mode Drop-on-demand Inkjet Printhead with Interchangeable Nozzle

High-Voltage Driver for Fully-Integrated Piezoelectric Inkjet Printhead Module

Addressable Multi-Nozzle Electrohydrodynamic Jet Printing with High Consistency by Multi-Level Voltage Method

Enhanced Resolution, Throughput, and Stability of Aerosol Jet Printing via In Line Heating

A 3D‐Printed Printhead: Custom Inkjet Dispenser for Medium Viscosity Fluids

A Simple Method for Fabricating Ink Chamber of Inkjet Printheads

Inkjet Printhead Arrays with No Separating Wall Between Bubbles

Nozzle-Driven Self-Priming Piezoelectric Inkjet Based on Capillary Action for Variable Angle Printing