Abstract:Purpose The purpose of this study is to solve the problem of longer dead-time in the rear bridge leg switches and lower efficiency in the Four-Switch Buck-Boost LLC Resonant Converter. Design/methodology/approach The paper adopts time-domain analysis to derive the time-domain expression for optimal dead time, analyzing the conditions for achieving soft switching of the transistors. It further explores the relationship between the dead time of the bridge arm switching transistors and the input/output of the converter under different operating conditions. Specifically, the dead time of the upper bridge arm transistors increases with the converter input voltage and decreases with the output current. In contrast, the dead time of the lower bridge arm transistors is independent of the converter output current and decreases with increasing converter input voltage. Findings By simulating and constructing a 500 W experimental prototype, experimental results indicate that designing the dead time of the switch according to the optimal dead time proposed in this paper significantly improves efficiency when the converter operates from heavy load to full load. When the transformer takes minimum input, maximum input and intermediate bus voltage inputs respectively, its peak efficiency is increased by 0.6%, 1.7% and 1.1%, respectively, compared to the traditional four-switch Buck–Boost LLC resonant converter. Originality/value Experimental validation confirms the correctness of the optimal dead time design and analyzes the impact of different operating conditions of the converter on the dead time. This is of significant importance for the rational design of switch dead times and the enhancement of converter efficiency.

Dead-time Optimization of SiC Devices for Voltage Source Converter

Model-Based Dead Time Optimization for Voltage-Source Converters Utilizing Silicon Carbide Semiconductors

Dead-time Effects Analysis and Elimination for Voltage Source Inverter

A GaN-based MHz Active Clamp Flyback Converter with Adaptive Dual Edge Dead Time Modulation for AC-DC Adapters.

Modeling and Implementation of Optimal Asymmetric Variable Dead-Time Setting for SiC MOSFET-Based Three-Phase Two-Level Inverters

Soft-switching SiC Power Electronic Conversion for Distributed Energy Resources and Storage Applications

A Double-Modulation-Wave PWM for Dead-Time-Effect Elimination and Synchronous Rectification in SiC-Device-Based High-Switching-Frequency Converters

Voltage Slew Rate Design with Soft Switching Technique

Analysis and compensation of dead-time effect in voltage source inverters considering parasitic capacitance and ripple current

Sic Mosfet Zero-Voltage-Switching Svm Controlled Three-Phase Grid Inverter

Dynamic Gate Delay Time Control of Si/SiC Hybrid Switch for Loss Minimization in Voltage Source Inverter

Modeling and Compensation for Dead-Time Effect in High Power IGBT/IGCT Converters with SHE-PWM Modulation

Optimization design of dead time in the four-switch buck-boost LLC resonant converter

Dead-time Compensation Method for Bus-clamping Modulated Voltage Source Inverter

A DC-DC Converter with Switched-Capacitor Delay Deadtime Controller and Enhanced Unbalanced-Input Pair Zero-Current Detector to Boost Power Efficiency

An Active Gate Driver Design to Reduce Voltage and Current Overshoots for SiC MOSFET Modules

Comprehensive optimization of ZVS variable frequency control for SiC/Si HANPC Converter

SiC Full-Bridge Grid-Tied Inverter with ZVS-switching

Adaptive Gate Delay-Time Control of Si/SiC Hybrid Switch for Efficiency Improvement in Inverters

Analysis and compensation of dead-time effect considering parasitic capacitance and ripple current

Adaptive Driving Scheme for ZVS and Minimizing Circulating Current in MHz CRM Converters