Abstract:Fly ash has been widely explored in alkali-activated concrete technology as a precursor; however, it suffers sudden brittle failure and requires heat activation for early-strength development. Previous studies have demonstrated that these shortcomings can be overcome by adding nanosilica and various types of fibers. However, they were mainly focused on improving the mechanical properties, but there is no clear understanding of the durability and microstructural changes. Therefore, this study systematically addresses the effects of nanosilica sol and hybrid fibers (steel and polypropylene fibers) on the workability, porosity, flexural/ compressive strength development, flexural toughness, crack resistance, and durability (subjected to sulfuric acid of pH = 1, 5% sodium sulfate, and 3.5% seawater attacks) of fly ash-based mortars cured at ambient environments. The results demonstrate that nanosilica and hybrid fibers have acceptable simultaneous effects on the properties of mortar. Although they both reduce fluidity, nanosilica improves the pore enlargement caused by fiber materials; thus, it greatly improves the mechanical properties of mortar. The flexural toughness of the mortar with nanosilica and hybrid fibers was approximately 200% higher than that of the pure-fly ash. Only approximately 58.25 mm2 microcracks were observed during the early crack detection, and the residual strength also improved under chemical solution attack. The microstructures were studied by field-emission scanning electron microscopy with energy-dispersive X-ray spectroscopy, X-ray diffraction/Rietveld method, and nanoscale 3D X-ray microscopy. The nanosilica enhanced the reactivity of the precursors and refined the pore structure of the mortar due to the changes in the crystalline and amorphous phases, and the hybrid fibers produced composites with good internal characteristics and strong fiber/matrix interfacial bonding.

Strength and microstructure of class C fly ash based geopolymer activated with sodium silicate powder

Synthesis and Properties of Fly Ash Geopolymer with Dyeing Sludge

Mechanical Properties And Microstructure Of Class C Fly Ash-Based Geopolymer Paste And Mortar

Study on Fabrication and Microstructures of Fly Ash Based Geopolymeric Cements

Properties of geopolymer based on fly ash

Mechanical behavior and microstructure evolution of slag-fly ash based geopolymer stabilized sand

Performances and microstructure of one-part fly ash geopolymer activated by calcium carbide slag and sodium metasilicate powder

Study on the Geopolymer Based on Fly Ash and Slag

A high-strength red mud–fly ash geopolymer and the implications of curing temperature

Fresh and Hardened Properties of One-Part Fly Ash-Based Geopolymer Binders Cured at Room Temperature: Effect of Slag and Alkali Activators

Microstructure, Compressive Strength and Sound Insulation Property of Fly Ash-Based Geopolymeric Foams with Silica Fume as Foaming Agent

Sulfate Resistance of Class C/class F Fly Ash Geopolymers

Efflorescence of fly ash-based geopolymer mortars under quasinatural conditions: The relationship between curing temperature, ion transport, and compressive strength

Development of Low-Calcium Fly Ash-Based Geopolymer Mortar Using Nanosilica and Hybrid Fibers

Physico-chemical properties and durability of a fly-ash-based geopolymer

Low-carbon wet-ground fly ash geopolymer activated by single calcium carbide slag

Study of Manufacture Process and Properties of Fly Ash-Based Geopolymers

Experimental study on performances of fly ash-based geopolymer cementitious material with low admixtures content

Study of In Situ Foamed Fly Ash Geopolymer

An efficient approach for sustainable fly ash geopolymer by coupled activation of wet-milling mechanical force and calcium hydroxide

Chloride resistance of class C/class F fly ash-based geopolymer mortars with different strength grades