Abstract:For conventional interleaved two-phase forward converters with a common output inductor, the maximum duty cycle is 0.5, which limits the voltage range and increases the difficulty of the transformer's optimization. A new two-phase hybrid forward converter with series-parallel auto-regulated transformer windings is presented in this paper. With interleaved control signals for the two phases, the secondary windings of the transformers can work in series when the duty cycle is larger than 0.5, and they can work in parallel when duty cycle is lower than 0.5. Therefore, the maximum duty cycle is extended and the turns ratio of the transformer can be optimized. Duty cycle dependent auto-regulated windings result in the steady states of the converter being different in different duty cycle ranges (D>0.5 and D<0.5). Fortunately, the steady state gains of the proposed hybrid converter are identical at different duty cycle ranges, which means a stepless shift between two states. A prototype is built to verify the theoretical analysis. A conventional control loop is compatible for the whole input voltage range and load range thanks to the stepless shifting between the different duty cycle ranges.

A hybrid-driven active clamp forward converter based on LM5027

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Wide Range Dual Switch Forward-Flyback Converter With Symmetrical Rcd Clamp

New Hybrid Driving Scheme for Srs to Improve the Efficiency of Active Clamped Forward Converter

An Improved Synchronous Rectification Circuit in Active-clamp Forward Converter

A Hybrid ZVS Full-Bridge Converter with Transformer Winding Series-Parallel Auto Regulated Current Doubler Rectifier

Small Signal Modeling And Analysis Of Interleaved Active-Clamp Forward Converter With Parallel Input And Series-Parallel Output

A New Five-Level Hybrid-Clamped Converter with Reduced Number of Clamping Devices

A Self-clamping Non-synchronous Duty Cycle Control Strategy for Hybrid Clamping Three-level Buck Converter with GaN Devices

High-frequency DC link grid-connected power conversion with Improved Active Clamp

Active-Clamp ZVZCS Resonant Forward DC Transformer (DCX) with Load-Adaptive ON-Time Control

A Third-winding and Current-driven Hybrid Driving Scheme for SRs of Active-clamped Forward-flyback Converters

Two-phase hybrid forward convertor with series-parallel auto-regulated transformer windings and a common output inductor

A Hybird Synchronous Rectification Scheme with Independent Turn-on and Turn-off Timing Control for SiC-Based CLLC Converters

Current-Feed Single-Switch Forward Resonant DC Transformer (DCX) with Secondary Diode-Clamping.

Feed-Forward Control of the Active Clamp Flyback Converters Based on LM5025

An Improved Boost-Type Hybrid Converter with Multiple Outputs

Current-Sharing Active-Clamped Forward Power Converter with Self-driven Synchronous Rectifier

High-Efficiency Hybrid Full-Bridge–Half-Bridge Converter with Shared ZVS Lagging Leg and Dual Outputs in Series

Self-driven Active-Clamped Forward Power Converter with Output Ripple-Cancellation for Aerospace Applications

Multi-Objective Optimization Control of A Four-Level Hybrid-Clamped Inverter