Abstract:This article presents a novel three-level (TL) converter control integrated circuit (IC) with a flying capacitor control loop, an adaptive constant on-time (ACOT) control, and a shared control circuit in bidirectional operation for the battery charger system. To solve the flying capacitor balance issue in TL converters, the flying capacitor control with single-point sensing (SPS) of switching voltage VX is proposed to balance the flying capacitor without a complex control and sensing circuit in an IC implementation. The proposed SPS also minimizes the inductor ripple. Besides, both directions (buck mode or boost mode) share the same control circuits except for the compensator to minimize the controller die area. The proposed scheme is realized with a 1.5 MHz switching frequency bidirectional TL converter IC in the TSMC 0.18 μm complementary metal-oxide-semiconductor (CMOS) process. The measurement result verifies that the functions are feasible in both directions, and there are no flying capacitor voltage runaway and mismatch issues. The proposed ACOT design achieves less than 6% switching frequency variation over the load range in boost mode, which is much smaller than conventional ACOT control. The proposed TL buck converter achieves an efficiency of 95.89% at 1-A load. The efficiency of the proposed TL boost converter is up to 96.02% at 0.5-A load.

A Self-clamping Non-synchronous Duty Cycle Control Strategy for Hybrid Clamping Three-level Buck Converter with GaN Devices

Voltage and Current Balancing Control for 48-V Two-Stage Hybrid-Switched-Capacitor Converter

A New Four-level Hybrid-Clamped Multilevel GaN Totem-Pole PFC

Two Variations of Five-Level Hybrid-Clamped Converters and Their Voltage Balancing Control Using Three Degrees of Freedom

Capacitor Voltage Ripple Reduction of A 4-Level Hybrid Clamped Converter Using Switching State Redundancy for Medium-Voltage Drive

Topology and Control of a Five-Level Hybrid-Clamped Converter for Medium-Voltage High-Power Conversions

A Neutral-Point Potential Balancing Control Method with Third Harmonic Injected Pulse Width Modulation for Three-Level Converters

Voltage Balancing Control of a Four-Level Hybrid-Clamped Converter Based on Zero-Sequence Voltage Injection Using Phase-Shifted PWM

A Novel Single-Stage Five-Level Common-Ground-Boost-Type Active Neutral-Point-Clamped (5L-CGBT-ANPC) Inverter

A Four-level Hybrid-Clamped Converter with Natural Capacitor Voltage Balancing Ability

A New Five-Level Hybrid-Clamped Converter with Reduced Number of Clamping Devices

A Capacitor Voltage Balancing Strategy for a Five-Level Hybrid-Clamped Inverter

Active Modulation Strategy for Capacitor Voltage Balancing of Three-Level Neutral-Point-Clamped Converters in High-Speed Drives

A Bidirectional Three-Level Converter Control With Shared Control Circuit and Single-Point Sensing for Flying Capacitor Balance

Multi-Objective Optimization Control of A Four-Level Hybrid-Clamped Inverter

Voltage-Balancing Strategy for Three-Level Neutral-Point-Clamped Cascade Converter under Sequence Smooth Modulation

Investigation of Hybrid Three-Level Hybrid Device (Hybrid<sub>2</sub>) Active Neutral-Point-Clamped Converter

The Topologies and Control of Hybrid-Clamped Four-Level and Five-Level Inverters

Investigation of Hybrid Three-Level Hybrid Device (Hybrid<inf>2</inf>) Active Neutral-Point-Clamped Converter

Voltage Balancing Control of a Three-Phase Hybrid-Clamped Five-Level Inverter Based on Optimal Zero-Sequence Voltage Injection

Adaptive Zero-Voltage-Switching Control and Hybrid Current Control for High Efficiency Gan-Based Mhz Totem-Pole Pfc Rectifier