Abstract:In an atomic vapor laser isotope separation process, the required isotope atoms are ionized selectively by a pulsed laser with a specific narrow line width, and then the produced isotope ions are extracted to the collected plates under an externally applied electromagnetic field. In the whole ion separation process, the ion extraction sub-process is one of the most important physical processes. Previous studies have shown that the key parameters of the laser-induced plasma, e.g., the initial electron number density and temperature, have a significant influence on the ion extraction features. In an actual isotope separation process, a specifically designed laser is necessary to produce the required isotope ions, which, however, leads the whole facility to have a very complicated structure, high capital cost, and especially, very narrow window of the key plasma parameters. These will, to some extent, limit a more in-depth investigation of the influences of the key plasma parameters on the ion extraction characteristics. In this paper, an ion extraction platform (ion extraction simulation experimental platform-2015, IEX-2015) is developed on the basis of a gas discharge plasma jet driven by a kilo-hertz high-voltage power supply. And an argon plasma "collisional-radiative" model is established to measure the electron temperature and number density in the plasma jet region. The experimental results show that the power input and driving frequency of the power supply and the argon mass flow rate can all affect the electron temperature and electron number density. The measured variation ranges of the electron number density and temperature are 10(9)-10(11) cm(-3) and 1.7-2.8 eV, respectively, under a chamber pressure on the order of 10(-2) Pa, which are close to the parameter levels in the actual ion extraction process. Subsequently, the preliminary ion extraction experiments are conducted under different extraction conditions including different externally applied voltages, different electrode distances and different plasma densities. The experimental results are also qualitatively consistent with those in an actual ion extraction process. The preceding preliminary experimental results show that it is feasible to conduct the ion extraction simulation study on IEX-2015. This is very helpful for systematically studying the ion extraction characteristics under different operating conditions in our future research.

Numerical simulation of charge exchange ions' affect in ion extraction for ion optics

Simulation of ion beam extraction and focusing system

Analysis and Particle-in-cell Simulation on the Similarity Relation During an Ion Extraction Process

On Optical Properties Of Ion Beams Extracted From Electron Cyclotron Resonance Ion Source

Numerical Simulations Using an Improved Calculational Scheme for Ion Charge State Distribution and Ion Temperature Evolution in an Ebit

Numerical simulation of magnetic field influence on plasma and electron extraction of electron cyclotron resonance neutralizer

Three-dimensional simulations of ion dynamics in the plasma of an Electron Cyclotron Resonance Ion Source

One-dimension Modeling on Parallel-plate Ion Extraction Process Based on Electron-equilibrium Fluid Model

Influence of the Decelerator Grid on the Optical Performance of the Ion Thruster

Extraction layer models for negative ion sources

Numerical Simulation of Beam-Extraction System and Grid Electrostatic Lens for I-4 Linear Accelerator

Influence of Extraction Voltage on Electron and Ion Behavior Characteristics

Numerical simulations on loss of ICRF-heated NBI ions in EAST

Particle simulation of collision dynamics for ion beam injection into a rarefied gas

Simulations of particle interactions in a high-current RFQ

Comparison between the experimental results and numerical simulation on the ion extraction process

Study of Simultaneous Acceleration of Positive and Negative Ion Beams by Dynamic Simulation in RFQ

Analytical and simulation studies for diode and triode ion beam extraction systems

Physical Characteristics of Ion Extraction Simulation System Based on Gas Discharge Plasma Jet

Three-dimensional simulation of electron extraction process and optimization of magnetic field based on multi-aperture structure of negative hydrogen ion source

3-D Simulation of Ion Thruster Plumes Using Octree Adaptive Mesh Refinement