Abstract:In order to predict VFTO (very fast transient overvoltage) distributions in the windings during transformer design stage, it is important to acquire the frequency range of the surge wave that could enter the transformer winding, and then model the windings in that frequency range. In GIS (gas insulated station), transformer is connected to bus through bushing and lead wire. The bushing capacitance to ground will bypass the high frequency components, so there should be a upper limit of the frequency components of the surge wave at the entrance of the transformer. In this paper, the transformer windings are modeled using MTL (multitransmission-line) model firstly, then the lumped equivalent circuit is formulated with the -type circuits, and finally the driving-point impedance and voltage transfer functions of the equivalent circuit are calculated using nodal analysis. The driving-point impedance of a model winding is calculated and compared with the measured result, and the validation of the equivalent circuit of transformer winding in the frequency range below 20 MHz is verified. Then the driving-point impedances of two real transformer windings are calculated with the equivalent circuit. Taking the lead impedance into consideration, the impedance of the winding is compared with the one of the bushing capacitance. The results show that most of the energy of the frequency components above 10 MHz in the surge wave will pass through the bushing capacitance and will not cause damage to transformer insulations.

Broadband frequency response analysis of transformer windings

Location of Partial Discharges Fault in Transformer Winding

Analysis Of Transformer'S Winding Vibration Characteristics Using Hilbert-Huang Transform

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

Experimental Characterization of Hybrid Temperature and Frequency Effects on the Performance of Transformers on Silicon Substrate

Deformation Analysis of Transformer Winding by Structure Parameter

Three-Dimensional Free Vibration Of A Power-Transformer Winding Model

A Circuit Model in a Wide Frequency Range for Power Transformer and Analysis of Its Characteristics

Investigation on broadband characteristics of losses in power transformer interturn insulation paper by dielectric relaxation model

Study on Broadband Loss Characteristics of Oil-Immersed Papers for Fast Transient Modeling of Power Transformer

Broadband Port Circuit Model for Distribution Transformers Based on Frequency Impedance Analysis

Comprehensive Analysis of Electric Field Characteristics for Multi-Winding Medium Frequency Transformer

Determining the Broadband Loss Characteristics of Power Transformer Based on Measured Transformer Network Functions and Vector Fitting Method

Piecewise Frequency-domain Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage Simulations

Proposed methodology for online frequency response analysis based on magnetic coupling to detect winding deformations in transformers

Macroscopic Broadband Loss Characteristics of Power Transformer Winding Extracted by Vector Fitting Method

Design and Analysis of Low Frequency Transformer Applied in Fractional Frequency Transmission System

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Wide Band Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage (VFTO) Analysis

Analyses on an electronic voltage transformer's failure by its resonance with very fast transient overvoltage and suppression

Analysis of transformer noise frequency spectrum under short-circuit and no-load conditions