Abstract:Common-mode (CM) electromagnetic interference (EMI) noise of a power converter is mostly due to the displacement current of the parasitic CM capacitance distributed between earth and the corresponding dynamic circuit node with very large dv/dt. In the layout of the printed circuit board (PCB) of a power converter, the power ground (GND) is an important factor to mitigate CM EMI, because it could act as a shield between earth and the dynamic circuit node. Taking a buck converter as an example, this paper proposes a method to evaluate the incomplete shielding effectiveness of GND on CM EMI emission. It first builds up a CM EMI model for the converter. The CM model is then used to analyze the shielding mechanism of GND on CM EMI. Numerical simulations are performed for comparison of shielding effectiveness of GND with different layouts. The simulation results show that the shielding effectiveness of GND increases conditionally with the mutual capacitance between the GND and the dynamic circuit node. The evaluation method and the simulation results are validated through experimental results.

Investigation of relationship between ground bounce and common-mode radiation

The Effects of Signal Trace's Termination on Ground Bounce and Common-Mode Radiation

Improved Eigenmode Expansion Method for Investigating of Ground Bounce in Power/ground Plane with Holes in PCBs

On the Evaluation of the Common-Mode Current along Twisted-Wire-Pairs

Modeling And Characterization Of Incomplete Shielding Effect Of Gnd On Common-Mode Emi Of A Power Converter

Quantification of EMI for Power-Ground Plane and Novel EBG Structure for SSN Suppression

EMI and EMC Analysis of Arbitrarily Shaped Power-Ground Planes

Investigation of Shorting Vias for Suppressing Common-Mode Radiation in Different Frequency Range

Near-Field Radiation Estimation and Its Reduction Using a Novel EBG for PCB

PCB Electromagnetic Interference Modelling Based on Reciprocity Theorem

A Novel Imaging Method for the Impedance Calculation of Power and Ground Planes

An Efficient Approach for the Power/ground Plane Equivalent Circuit Extraction

An EM Imaging Method Based on Plane-Wave Spectrum and Transmission Line Model

Efficient Analysis of Radiated Immunity of Printed Circuit Boards Using SPICE

Analysis on the Effectiveness of High Speed Printed Circuit Board Edge Radiated Emissions Based on Stimulus Source Location

Modeling And Evaluation Of Common-Mode Interference Coupling Effects On Sensitive Cable In Motor Drive System

Electromagnetic Shielding Analysis of Different Grounded Bump Distribution in SiP

Analysis of Rectangular Power-Ground Plane Pairs for Noise Suppression

A Novel Electromagnetic Bandgap Design Applied for Suppression of Printed Circuit Board Electromagnetic Radiation

Efficient Modeling of Rerouted Return Currents in Multilayered Power-Ground Planes by Using Integral Equation