Abstract:In recent years, with the continuous development of installed grid capacity and renewable energy, DC power transmission and distribution technologies have developed rapidly. As one of the most important high power semiconductor devices, the integrated gate commutated thyristor (IGCT) has great potential in DC grid application. The gate-cathode blocking property is the key for device packaging and working. Based on the corrosion process of the GCT chip, two methods are proposed for improving the consistency of gate-cathode blocking voltage in this paper. Introduction With fast growing power generation capacity and evolving clean energy, DC transmission and distribution technologies have developed rapidly recent years, due to advantages such as large transport capacity, extra long-distance transportation and lower loss. Integrated gate commutated thyristor (IGCT) is a kind of fully controlled power electronic device and its excellent blocking voltage and high current turn-off capability make it suitable for high-capacity applications such as DC breakers[1, 2] and SVCs, etc. However, there are many important factors influencing the usage of IGCT, the properties between gate and cathode is one of them. This paper analyzes and discusses the corrosion process of the GCT chip part of IGCT, and proposes two corrective methods from the aspects of process sequence and process operation based on process and device simulation results. Process Introduction of Gate-Cathode Units Figure 1 shows the schematic of the integrated gate commutated thyristor (IGCT), which consists of the GCT chip, the housing package and the gate drive circuit. The turn-off process of IGCT is shown in Figure 2[3], through the instant applied reverse voltage provided by the gate driver between gate and cathode, the cathode current is transferred to the gate. After this transformation, the device changes into an open-gate PNP transistor and turns off the current gradually. Figure 1. The schematic of an IGCT. To complete the transformation successfully, the PN junction between the gate and the cathode must withstand the reverse voltage applied by the external drive. Any PN junction unit with a lower

Characterization of IGCT under Zero-Current-transition Condition

Experimental Investigation on the Turn-Off Current Redistribution Characteristics of IGCT Based on an Isolated Anode Design

Characterising Trench Igbts in Resonant Switching Using Single Ended and Half-Bridge Application Circuits

Experimental Investigation on the Turn-Off Failure Mechanism of IGCT

Enhancing Turn-off Performance in IGCT-Based High Power Applications—Part I: Anomalous High Current Turn-Off Mode and Safe Operating Area Expansion at Ultra-Low Voltage

Experimental Evaluation of IGCT Converters with Reduced Di/dt Limiting Inductance

Characteristics Of Trench Gate And Dmos Igbts In A Zcs Single-Ended Resonant Inverter

Enhancing Turn-off Performance in IGCT-Based High Power Applications—Part Ⅱ: Hybrid Switch with IGBT Integration and Experimental Validation

Capacitor Switched Gate-Turnoff Thyristor

Trench Gate IGBTs for Zero Current Switching Applications

An IGCT-Series-Based DC Transformer with Quasi-Zero Switching Loss Modulation by Minimum Backflow Power Injection

IGCT AND IEGT--NEW HIGH POWER SILICON SWITCHES SUITABLE FOR STATCOM

Ultra-Low On-State Voltage IGCT for Solid-State DC Circuit Breaker with Single-Switching Attribute

A Novel Multistage Gate Unit of Integrated Gate Commutated Thyristor

Snubberless Switching-Off Characteristics of Igcts Equipped in High Power Three-Level Neutral Point Clamped Converters

Research on Series and Parallel Characteristics of Intergrated Gate Commutated Thyristors

Principle-electrics Model of IGCT and Dynamic Characteristic Simulation

A voltage controlled current source gate drive method for IGBT devices

Characteristics Analysis and Loss Optimization of the Turn-on Clamp Circuit for IGCT Based DC Transformer

Abnormal Turn-ON Phenomenon of Large-Size and High-Voltage Reverse Blocking IGCT

Improvement of Corrosion Process for Gate Commutated Thyristor Chips