Abstract:A new non-isolated modified SEPIC front-end dc-dc converter for the low power system is proposed in this paper, and this converter is the next level of the traditional SEPIC converter with additional devices, such as two diodes and splitting of the output capacitor into two equal parts. The circuit topology proposed in this paper is formulated by combining the boost structure with the traditional SEPIC converter. Therefore, the proposed converter has the benefit of the SEPIC converter, such as continuous input current. The proposed circuit structure also improves the features, such as high voltage gain and high conversion efficiency. The converter comprises one MOSFET switch, one coupled inductor, three diodes, and two capacitors, including the output capacitor. The converter effectively recovers the leakage energy of the coupled inductor through the passive clamp circuit. The operation of the proposed converter is explained in continuous conduction mode (CCM) and discontinuous conduction mode (DCM). The required voltage gain of the converter can be acquired by adjusting the coupled inductor turn’s ratio along with the additional devices at less duty cycle of the switch. The simulation of the proposed converter under CCM is carried out, and an experimental prototype of 100 W, 25 V/200 V is made, and the experimental outcomes are presented to validate the theoretical discussions of the proposed converter. The operating performance of the proposed converter is compared with the converters discussed in the literature. The proposed converter can be extended by connecting voltage multiplier (VM) cell circuits to get the ultra-high voltage gain.

Design of a Monolithic Low Voltage High Efficiency Boost DC-DC Converter ASIC Based on 0.5/spl Mu/m CMOS Process

Monolithically Integrated Boost Converter Based on 0.5-<tex>$mu$</tex>m CMOS Process

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

Design of A Monolithic High Frequency Fast Transient Buck for Portable Application

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Bi-directional On-Board Charger Architecture and Control for Achieving Ultra-High Efficiency with Wide Battery Voltage Range

A High Performance Integrated Boost DC-DC Converter for Portable Power Supply

An 8A 998A/inch<SUP>3</SUP> 90.2% Peak Efficiency 48V-to-1V DC-DC Converter Adopting On-Chip Switch and GaN Hybrid Power Conversion

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

Analysis and Design of Monolithic DC/DC Converters

A Monolithic Low-Power Buck Converter Integrated in Cmos Process

High-Efficiency High-Density MHz Cellular DC/DC Converter for On-Board Charger

A Monolithic High-Performance Buck Converter with Enhanced Current-Mode Control and Advanced Protection Circuits

High Efficiency Realization of a DC-DC Converter at Light Loads for Portable Applications

Highly Efficient Fully Integrated Multivoltage-Domain Power Management With Enhanced PSR and Low Cross-Regulation

Design and Development of Non-Isolated Modified SEPIC DC-DC Converter Topology for High-Step-Up Applications: Investigation and Hardware Implementation

A CMOS hybrid control mode DC-DC buck converter for embedded system

Design And Modeling Of A High Efficiency Step-Up/Step-Down Dc-Dc Converter With Smooth Transition

An Ultrahigh Step-Down DC-DC Converter Based on Switched-Capacitor and Coupled Inductor Techniques

High-conversion-ratio buck regulator for SoC in 0.13µm digital CMOS process

A Monolithic All-1.8V-Thin-Gate-NMOS KY-Boost Converter With Reused Flying-Capacitor Bootstrap Gate Driver Achieving 94.42% Peak Efficiency