Abstract:In portable electronic devices, the output voltage of the Ni-MH cell battery gradually decreases with the extension of run time, eventually leading to an inability to provide the required operating voltage. As a result, this paper proposed a non-inverting buck-boost converter with automatic switching of operating modes to extend the run time of Ni-MH batteries connected in series, which is peak current controlled. By comparing the input and output voltages, the DC-DC converter is placed in either buck, boost, or buck-boost mode. Of the three modes, the buck-boost mode is designed to have the smallest operating range due to its lowest power conversion efficiency. The converter is characterised by a wide input range of 2.5-8V, which exceeds the maximum voltage leading to oxide breakdown. In order to prevent the breakdown of the gate oxide layer, a capacitive coupling level shift circuit is proposed to control voltage between gate and source of the power transistor below 5V. The proposed converter is manufactured using a 180nm BCD process and occupies an effective chip area of 1.44mm×0.73mm. Experimental results demonstrate that the maximum power conversion efficiency of the proposed buck-boost DC-DC converter is 93%, marking a significant 11% enhancement compared to the traditional buck-boost DC-DC converter operating in only buck-boost mode (84% efficient). In addition, the converter achieves a maximum output current of 500mA, which improves the output maximum current by 67% compared to the traditional DC-DC converter (max. output current 300mA).

A High Performance Integrated Boost DC-DC Converter for Portable Power Supply

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

A 750Ma,dual-Mode PWM/PFM Step-Down DC-DC Converter with High Efficiency

Design of Interleaved Boost Converter in Energy-Feedback Electronic Power Load

Monolithically Integrated Boost Converter Based on 0.5-<tex>$mu$</tex>m CMOS Process

Design of High-gain Converter for Low Input Voltage and High Input Current in Energy Feedback Electronic Load System

Design of a Monolithic Low Voltage High Efficiency Boost DC-DC Converter ASIC Based on 0.5/spl Mu/m CMOS Process

An 8A 998A/inch<SUP>3</SUP> 90.2% Peak Efficiency 48V-to-1V DC-DC Converter Adopting On-Chip Switch and GaN Hybrid Power Conversion

A Fully Integrated Heterogenous Si-CMOS/GaN 500 MHz 6 V-to-18 V Boost Converter Chip

High Efficiency Realization of a DC-DC Converter at Light Loads for Portable Applications

High Efficiency High Integration Green Converter

High Frequency Multicell Cascaded Quasi-Square-Wave Boost Converter

Design and Integration of Beyond-10MHz High Switching Frequency DC-DC Converter

Design of A Monolithic High Frequency Fast Transient Buck for Portable Application

A Monolithic High-Performance Buck Converter with Enhanced Current-Mode Control and Advanced Protection Circuits

A 1μW-to-158μW Output Power Pseudo Open-Loop Boost DC-DC with 86.7% Peak Efficiency using Frequency-Programmable Oscillator and Hybrid Zero Current Detection.

Hybrid Modulated DCDC Boost Converter for Wearable Devices

A Novel Current-Mode Boost Converter With Depletion-Mode Mosfet

Design of a high efficiency and low EMI boost converter using bi-frequency PFM control scheme

A CMOS hybrid control mode DC-DC buck converter for embedded system

A 2.5-8V input range peak-current-control non-inverting buck-boost DC-DC converter with high efficiency and automatic mode transition for Ni-MH battery application