Abstract:Permanent-magnet synchronous generator (PMSG) are used widely in wind turbine applications. The performance analysis of PMSG can be enhanced by adopting a number of control mechanisms with the benefit of advanced optimization techniques. Renewable energy is harnessed from continuously replenishing natural processes. Some commonly known are sunlight, water, wind, tides, geothermal heat and various forms of biomass. The focus on renewable energy has over the past few decades intensified greatly. This paper presents modeling and control strategy for the grid connected wind turbine system based on Permanent Magnet Synchronous Generator (PMSG). The considered system is based on back-to-back converter topology. The Grid Side Converter (GSC) achieves the DC bus voltage control and unity power factor. The Machine Side Converter (MSC) assures the PMSG speed control. The PMSG is used as a variable speed generator and connected directly to the turbine without gearbox. The pitch angle control is not either considered in this study. Further, Optimal Tip Speed Ratio based MPPT control strategy is used to ensure the most energy efficiency whatever the wind speed variations. A filter (L) is put between the GSC and the grid to reduce current ripple and to improve the injected power quality.During grid faults, a hierarchical coordinated control scheme for the generator-side converter, main grid-side converter and auxiliary grid-side converter, depending on the grid voltage sags, is presented to enhance the low voltage ride through (LVRT) capability of the direct-driven PMSG WT.

Multi-converter Operation of Variable Speed Wind Turbine Driving Permanent Magnet Synchronous Generator During Network Fault

Back-to-back Converter Control of Grid-connected Wind Turbine to Mitigate Voltage Drop Caused by Faults

Application of Modular Multilevel Converter in Medium Voltage High Power Permanent Magnet Synchronous Generator Wind Energy Conversion Systems

Fault-tolerant Control Strategy of Dual Three-phase PMSG for Wind Turbines

Fault-Tolerant Control Technique of Permanent Magnet Synchronous Generator Based on Open Winding Configuration

Multi-switching Table Based Direct Power Control for the Grid-side Converter of Doubly Fed Induction Generator Wind Turbines

Improved VSG Control Strategy for Wind Turbines Connected to Non-Synchronized Grid under Commutation Failure

Dual Stator Windings PMSG Fed by Half-Controlled Converters for Wind Power Application

Investigation on Open Winding Pmsg System with the Integration of Full Controlled and Uncontrolled Converter

Analysis and Performance Of Grid Connected Straight Driven Pmsg Based Wind Turbines

Improved Control Strategy of an Active Crowbar for Directly-Driven PM Wind Generation System under Grid Voltage Dips

A Low Voltage Ride Through Control Strategy for PMSG Based on Electromechanical Energy Storage

Unit Power Factor Control of Direct-Drive Permanent Magnet Wind Generator

Sensorless Control of Pmsg Based on Dual Two-Level Inverter Open Winding Configuration for Wind Turbines

Complementary half controlled converter for directly-driven PM synchronous generator in wind power generation application

Simulation of Multi Directly-Driven Permanent Magnet Synchronous Generator Parallel Operation Based on PSCAD/EMTDC

Enhanced Control Strategies of Permanent Magnet Synchronous Wind Power Generation System under Unbalanced Grid Voltage Conditions

Novel Topology and Control Strategy of HVDC Grid Connection for Open Winding PMSG Based Wind Power Generation System

Grid-forming control strategy for PMSG wind turbines connected to the low-frequency AC transmission system

Synergetic control for stand-alone permanent magnet synchronous generator driven by variable wind turbine

Power quality control and design of power converter for variable-speed wind energy conversion system with permanent-magnet synchronous generator