Abstract:Offshore wind power generation equipped with conventional grid following controls challenges the power system stability by reducing the inertia of the grid and weakening the AC offshore grid. To overcome this vulnerability a promising solution could be equipping the wind turbines with grid-forming (GFM) control schemes. Many methodologies have been presented in the literature for GFM inverters. In spite of this, their applications for WTGs have not been thoroughly explored. This paper presents the study of fault handling capability of wind turbines with several grid-forming control strategies. In this context, four different control schemes i.e. Visynch, P/f droop, Q/f droop and conventional grid following control are considered. The performance of these control strategies is assessed and compared during a three-phase symmetrical fault on the point of common coupling of an offshore wind farm. A case study which consists of two wind turbines connected to the main converter of an offshore substation equipped with grid-forming control is also considered. The results indicate that, during faults, each of the four control strategies (Visynch, P/f droop, Q/f droop, and Gfol) effectively limits the current and restores normal operation. A significant advantage of Q/F droop control is its reduced sensitivity to variations in system and fault parameters, adjustable frequency response, and independence from existing Phase-Locked Loops (PLLs). On the other hand, the P/f droop control provides greater voltage support during faults due to its voltage controllers. However, post-fault oscillations result from the stiff voltage controller. Visynch control, on the other hand, shows a lower margin of stability. The advantages and weaknesses of each control scheme is revealed using the simulation results.

Back-to-back Converter Control of Grid-connected Wind Turbine to Mitigate Voltage Drop Caused by Faults

From Grid Feeding to Grid Supporting Converters: A Constant Power Active Distribution Network Perspective.

Control Method for Fault Ride-through of DFIG-based Wind Turbines Applied to Weak Grids

Analysis and Performance Of Grid Connected Straight Driven Pmsg Based Wind Turbines

Enhanced Control of DFIG-used Back-to-back PWM VSC under Unbalanced Grid Voltage Conditions

Improved Control Strategy of an Active Crowbar for Directly-Driven PM Wind Generation System under Grid Voltage Dips

Multi-switching Table Based Direct Power Control for the Grid-side Converter of Doubly Fed Induction Generator Wind Turbines

Doubly Fed Induction Generator Wind Turbine Systems Subject to Recurring Symmetrical Grid Faults

Wind turbine with line-side PMSG FED DC-DC converter for voltage regulation

A Grid Fault Tolerant Doubly Fed Induction Generator Wind Turbine via Series Connected Grid Side Converter

Improved VSG Control Strategy for Wind Turbines Connected to Non-Synchronized Grid under Commutation Failure

Unit Power Factor Control of Direct-Drive Permanent Magnet Wind Generator

Dual Stator Windings PMSG Fed by Half-Controlled Converters for Wind Power Application

A PMSG Wind Energy System Featuring Low-Voltage Ride-through via Mode-Shift Control

Control of Variable Pitch, Variable Speed Wind Turbine in Weak Grid Systems

Evaluation and Comparison of Different Methods for Improving Fault Ride-Through Capability in Grid-Tied Permanent Magnet Synchronous Wind Generators

Fault Handling Capabilities of Grid-Forming Wind Turbines in Offshore Wind Farms Connected With MMC HVDC System

Unified Grid-Forming Control of PMSG Wind Turbines for Fast Frequency Response and MPPT

Grid-Impedance-Based Transient Current Control for Offshore Wind Turbines under Low-Voltage Fault

Grid-forming control strategy for PMSG wind turbines connected to the low-frequency AC transmission system

Real‐Time Fault Ride Through Capability Improvement of PMSG‐Wind Turbine Based on Robust Fractional Order Sliding Mode Control