Abstract:A new theory of designing dual-band power divider (PD) based on Wilkinson structure is presented in this paper. Because of the utilization of coupled lines, the proposed PD is with a high design freedom that many transmission line (TL) combinations can be used for a fixed frequency ratio k (f(2)/f(1)). Meanwhile, since the lengths of the conventional coupled lines used are extremely long, the slow-wave structure is introduced, which configuration results in a property of designable length and compact size because of the improved space efficiency. After analysing the even- and odd-mode circuits, precise design formulas are derived and further verified for the frequency ratio from 1.5 to 6.0 using NI AWR simulator under the consideration of the largest realizable TL impedance as 128 Omega. For verification, two PDs with the same centre frequency of 1.0 GHz and 4.0 GHz but different TL configurations are designed based on the proposed design theory. According to the experimental results, both fabricated PDs have good performances as expected, such as low in-band insertion loss (S-21), wide isolation, and relatively better out-of-band rejection than majority of previous studies that the maximum S-21 between the two passbands is larger than 6 dB, while previous studies are around 4 dB.

A new design of compact microstrip Wilkinson power dividers

A Compact Gysel Power Divider with Unequal Power-Dividing Ratio Using One Resistor

Miniaturized Microstrip Wilkinson Power Divider with EBG Structure

Compact Ultra-Wideband Wilkinson Power Divider in Parallel Stripline with Modified Isolation Branches

A simple design of low-loss quad-band Wilkinson power dividers

Design of A Compact Wilkinson Power Divider with High Order Harmonics Suppression

A New Dual-Band Wilkinson Power Divider

A tri-band Wilkinson power divider using extended T-shaped stubs

Novel Design of Wilkinson Power Dividers with Arbitrary Power Division Ratios

Novel Wilkinson Power Divider with Uniform Impedance Line

Ultra-Compact Wideband Dual-Mode Wilkinson Power Divider Based On Thin Film Integrated Passive Device Fabrication Technology

Compact Microstrip Power Divider with Both Sides Capacitor Loading

Stub-Loaded Wilkinson Power Divider with Performance Enhancement.

A New Quad-Band Wilkinson Power Divider

A Novel Compact, Wideband Four-Way Wilkinson Power Divider with an Improved Isolation Topology

The Design and Miniaturization of 6-15 GHz Lumped-Element Wilkinson Power Divider Based on GaAs IPD Technology

Dual-band Wilkinson Power Divider Based on SS-CML

A 10:1 Unequal Wilkinson Power Divider Using Coupled Lines with Two Shorts

Novel Design of Dual-Band Unequal Wilkinson Power Divider

Analysis and design of a novel coupled-line wideband Wilkinson power divider

Design Method of Dual-Band Wilkinson Power Divider with Designable Length and High Design Freedom