Abstract:Silicon photomultipliers (SiPM) are rapidly adapted in simultaneous time of flight (TOF) PET and MRI imaging system in recent years due to its fast timing response and immunity to magnetic field. The aim of this work is to develop multi-channel fast SiPM readout electronics for clinical TOF PET detector. The detector module is assembled by directly coupling a 12x12 LYSO crystal block to an 8x8 Sensl FB30035 SiPM array. We are developing two approaches of compact readout electronics to handle the large number of SiPM output channels. One is a low noise and high bandwidth, 128-channel ASIC to readout the 64 fast outputs and 64 standard outputs of the 8x8 SiPM array. The other approach is a conventional electronics based multiplexing readout scheme using discrete components. A charge division resistor network reduced 64 channels of standard output to four energy signals, and multiplexing and summing circuits reduced 64 channels of fast output to one timing signal, making the detector block highly compact and scalable. The ASIC design has been finished and it's ready for tape-out. Preliminary performance of the detector module readout by conventional electronics was evaluated. 12x12 LYSO crystals were well resolved and identified in the flood image and the average energy resolution was 15.6% +/- 1.3%. For single crystal pair, 240ps coincidence resolving timing (CRT) was achieved. It was dropped down to 500ps for detector block to single crystal configuration, due to the combination effects of: 1) degradation of fast signal rising edge by output capacitance addition of SiPMs and 2) large white electronic noise and ultrahigh dark count rate. The readout design will be further optimized by increasing the signal bandwidth and reducing noise to get better timing performance at a cost of increasing circuit complexity to a reasonable level. The performance of ASIC readout will be evaluated and good timing performance is expected due to the individual pixel timing pick-off.

SENSROC4: an Multichannel Low-Noise Front-End Readout ASIC Dedicated to CZT Detectors for PET Imaging

Development Of A Low Noise Readout Asic For Czt Detectors For Gamma-Ray Spectroscopy Applications

Design of A Monolithic Multi-Channel Front-End Readout Asic for Lyso/Sipm-Based Small-Animal Flat-Panel Pet Imaging

Development Of A Multi-Energy Photon-Counting Readout Asic For Czt Detectors

Development of a Compact and Cost-Effective PET Detector Module for a Small-Animal PET System with FESA ASIC

An Analog Front-end ASIC Design for 16-Channel SiPM Readout in PET Detectors

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

Development of a Pixel Readout ASIC for CZT Detectors for Spectral X-ray Photon-Counting Imaging Applications

Development of a 64-Channel Readout ASIC for an ${8 \times 8}$ SSPM Array for PET and TOF-PET Applications

Development Of Multi-Channel Fast Sipm Readout Electronics For Clinical Tof Pet Detector

Development of a 64-Channel Readout ASIC for an SSPM Array for PET and TOF-PET Applications

A Multi-Channel Front-End ASIC for Pixellated Detectors

Design of A Low Noise Readout Asic for Cdznte Detector

Development of a Multi-Channel ASIC with Individual Energy and Timing Digitization for SiPM Detectors for TOF-PET Applications

Electronics for monolithic scintillator PET detector modules based on neural network position estimators

A Low Noise Readout Asic for Cdte/Cdznte Detectors

Design of a Low-Noise, High-Linearity, Readout ASIC for CdZnTe-based Gamma-Ray Spectrometers

PETAT -- An ASIC for Simple and Efficient Readout of Large PET Scanners

Development of an Eight-Channel Time-Based Readout Asic for Pet Applications

Fpga Based Electronics For Pet Detector Modules With Neural Network Position Estimators

Low power implementation of high frequency SiPM readout for Cherenkov and scintillation detectors in TOF-PET